Daintree GE current Lumination LIB Manuel d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Daintree GE current Lumination LIB. Daintree GE current Lumination LIB 4 pages. Linear in-bay lighting

Imprimer la page
Lumination® LIB
Continuous Run Installation - Power Linking Cords
3
A
"Snap" the luminaires into the
correlating mounting brackets,
centering the length of the
fixtures within the brackets.
D
Plug the power cord into a
120VAC supplied outlet.
(The maximum distance to
the receptacle is determined
by the length of cord
provided.)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. CAN ICES-005 (A) / NMB-005 (A)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
Questions
Web: products.gecurrent.com
All product and company names are trademarks or registered trademarks of their respective holders. Use of them does not imply any affiliation
with or endorsement by them.
B
Select the "linking cord" most
similar in length to the gap
between the two luminaires
without causing strain. Connect
the linking cord to male and
female connectors respectively.
Phone: 1-866-855-8629
2020 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the General
Electric Company and are used under license. Information provided is subject to change without notice. All values are
design or typical values when measured under laborator conditions.
IND 570 | A-1026549 | REV 07/22/20
Installation Guide
C
Connect the protective cap to
the unused female connector.
Remove the protective film on
the diffuser. Connect the power
cord to the male connector.