DSC 2550 Manuel des questions fréquemment posées
Parcourez en ligne ou téléchargez le pdf Manuel des questions fréquemment posées pour {nom_de_la_catégorie} DSC 2550. DSC 2550 18 pages.
Imprimer la pageMost Frequently Asked Questions
DSC 2550
TO CHANGE OR ADD A CODE:
Press *5
•
Enter your master On/Off code
•
Enter user number to change (1 - 8)(master code is 1)
•
Enter new 4 digit code
•
Press # #
•
Get a green ready light and test your new code.
•
TO CHANGE OR ADD A CODE:
Press *5, Enter your master On/Off code, Enter user number to change (1 - 8), Enter new 4 digit code, Press # #. Get a
•
green ready light and test your new code.
MY YELLOW TROUBLE LIGHT IS ON &/OR BEEPING:
To Silence the keypad beeping at any time, press (*) (2) (#). The trouble light will remain on until the trouble
•
condition is cleared, but the beeping will stop.
• Press (*) (2) to determine what the trouble is
One of the zone numbers will be illuminated. This zone number corresponds to one of the the trouble conditions listed below.
Please call or e-mail for help in resetting your system. The yellow trouble light should never be on.
Trouble 1=Low back-up battery in the main control panel (basement or utility room).
You will need to replace your 12v 5 ah rechargeable battery - we can send it to you via UPS for you to change yourself or
•
you can schedule a service call.
Trouble 2=Electric Failure
Electric is out
•
Alarm transformer is unplugged
•
Circuit breaker is tripped
•
Trouble 4=No Dial tone on your land line phone (call your phone line provider)
Did you get rid of your land line?
•
Did you change phone line providers?
•
Did you switch from Comcast to Verizon?
•
Did you change or move your phone modem?
•
Trouble 5=Failure to communicate to central station. This means the alarm was activated but the signal did not reach the central
station.
Did you get rid of your land line?
•
Did you change phone line providers?
•
Did you switch from Comcast to Verizon?
•
Did you change or move your phone modem?
•
You can try to reset your phone modem and then call to test the alarm into the central station. In some cases, the central station
can help clear this trouble.
Trouble 6=Bell Circuit Trouble
Trouble 7=Smoke detector Circuit Trouble
Trouble 8= Loss Of Time on System Clock - (see below to reset time)
TO SET CLOCK (trouble 8)
Step 1 – Enter time/date programming by pressing [*][6] + [Master Code] + [1]
•
Step 2 – Enter [HH:MM]
•
Step 3 – Press [#] to exit
•
Note: Program the time using military standard (e.g. 8:00 pm = 20:00 hours)
For Example: 8:00 pm [*] [6] + [4 Digit on/off code] + [1] 2000 [#]
For Example: 8:00 am [*] [6] + [4 Digit on/off code] + [1] 0800 [#]