DSC PC 5010 Manuel rapide - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} DSC PC 5010. DSC PC 5010 20 pages.
Également pour DSC PC 5010 : Manuel d'instruction (10 pages)

Imprimer la page

If An Alarm Sounds

Fire Alarm

If your system has been installed with fire detectors and the alarm sounds in a pulsing mode, follow

your emergency evacuation plan immediately (see "Fire Escape Planning" on page 15).

Intrusion Alarm

If an intrusion alarm sounds, indicated by a continuous bell or siren, the alarm may be silenced by

entering your access code. If the alarm was unintentional, call local authorities immediately to avoid an

unnecessary response.

You can determine the source of the alarm by following the instructions in the "Disarming" section (see

page 6). Once the source of the alarm has been corrected, the panel can be restored to its original

Armed state.

Function Keys

Each keypad has five function keys, located to the right of the number pad, which allow easy single-

button activation of the most commonly used features. If these keys have been enabled by your

installer , you can execute their programmed function by pressing and holding the corresponding key

for two seconds.

For information regarding the operation of the function keys, talk to your alarm installer.

Programming Security Codes

Programming codes from an LED Keypad:

The Master Code

To program the Master Code, enter [ ][5][current Master Code][40][new Master Code]. The Master

Code must be four digits unless otherwise indicated by your installer. Enter digits 0 through 9 only.

Press [#] to return to the Ready state.

Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We

recommend that the factory default Master Code [1234] not be used.

Additional Codes

Up to 32 additional access codes (01 through 32) may be programmed.

To program a new code:

Enter [ ][5][Master Code][code number 01 to 32][new access code]. The code number is a double digit

from 01 to 32. Access codes must be four digits unless otherwise indicated by your installer. Enter

digits 0 through 9 only. Press [#] to return to the Ready state.

If an access code already exists for the code number you have selected, it will be replaced by the new

code. Be sure to record your new code(s) on the "System Information" page in this book.

To erase a code:

Enter [ ][5][Master Code][code number 01 to 32][ ]. Press [#] to return to the Ready state. Do not

erase the Master code.

Continued on page 10...