ANSI ROPE TERMINATION ANCHOR Manuel d'instruction de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction de l'utilisateur pour {nom_de_la_catégorie} ANSI ROPE TERMINATION ANCHOR. ANSI ROPE TERMINATION ANCHOR 8 pages.

Imprimer la page
Rope Threading:
Ÿ
Pass the attachment end of the rope through hole1, and pull
Ÿ
the rope through the hole.
Insert the attachment end rope through hole 2 and pull
Ÿ
through without making any slack.
Continue by attachment rope end through hole 3 and pull
Ÿ
through so that there is no slack.
Thread the rope end through hole 4 and pull through so there
Ÿ
is no slack.
Thread rope end through hole 5 & pull through. Leave a 1"
Ÿ
diameter loop of slack.
Now Position the rope end around to back of
Ÿ
Termination Anchor
Firmly pull the rope end until loop tightens to form a knot,
Ÿ
Ensure there is no rope slack over entire length of
Termination Anchor
6.
ADVISE & INFORMATION:
It is essential to verify that the medical condition of the user is to use
Ÿ
the connectors in normal & emergency use i.e. user must be
medically t to use the device.
A rescue plan shall be in place to deal with any emergencies that
Ÿ
could arise during work.
It is prohibited to make any alterations or additions to the equipment
Ÿ
without the manufacturer prior written consent, and any repair shall
only be carried out in accordance with manufacturers procedures.
Equipment shall not be used outside its limitation, or for any purpose
Ÿ
other than that for which it is intended.
Rope Termination Anchor
Ÿ
It is essential for safety that equipment is withdrawn from use immediately if ever subjected to a fall arrest. Do not use again until
Ÿ
conrmed in writing by a competent person that it is acceptable to do so.
Ensure that the strength of the anchorage member used is greater than 5000lbs.(22.2 kN).
Ÿ
7.
MATERIAL : Aluminium
8.
MAINTENANCE, CLEANING, AND STORAGE :
If the Rope Termination Anchor fails inspection in any way, immediately remove it from service, and contact TheHarnessDepot for
Ÿ
all maintenance and repair needs.
Cleaning after use is important for maintaining the safety and longevity of
Ÿ
Remove all dirt, corrosives, and contaminants from
Ÿ
If
Rope Termination Anchor
Ÿ
Termination Anchor
with corrosive substances.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals, or other degrading
Ÿ
elements.
Rope
and insert through 1" diameter loop.
.
are personal property of the user.
Rope Termination Anchor
cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean
6
5
4
Rope
3
2
1
Rope Termination Anchor.
before and after each use.
2
PFAS Attachment
Point
Under
Pull Through loop
and tighten Knot.
Leave 1"
loop.
Rope