DAITEM 144-21X Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} DAITEM 144-21X. DAITEM 144-21X 14 pages. Special animal immune external detector

Imprimer la page

9. Maintenance

9.1 Fault indication

The control panel takes battery faults, anti-tamper faults and

radio faults on the detector into account.

• Battery fault: following a system command, the control panel

issues the following voice message:

"beep, fault, battery, detector X"

• Anti-tamper fault: following a system command, the control

panel issues the following voice message:

"beep, fault, anti-tamper, detector X"

• Radio fault: following a system command, the control panel

issues the following voice message:

"beep, fault, radio, detector X"

9.2 Changing the battery

IMPORTANT: the detector's configuration is saved when the battery is

changed.

1. Switch the control panel to installation mode and ask the

master user to press:

master code

then press:

engineer installer code

2. Open the case of the detector (see § Opening).

3. Disconnect the cables from the detection module to the radio

board.

4. Replace the used lithium batery.

5. Reconnect the cables from the detection module to the radio

board.

6. Close the case of the detector.

7. Switch the control panel back to user mode, press:

engineer installer code

IMPORTANT: the test button makes it possible to check if the battery is OK.

The indicator on the radio board lights red when the button is pressed.

• The lithium battery pack must be replaced by the same type of pack with

the same technical characteristics, i.e. (3.6 V - 4 Ah).

• We advise you to use the DAITEM BatLi05 pack available

in the catalogue in order to guarantee individual safety

and equipment reliability.

• Dispose of the waste lithium power pack in an appropriate

recycling bin.