DSC PowerSeries PC1832 Manuel - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DSC PowerSeries PC1832. DSC PowerSeries PC1832 18 pages. System enhancement module
Également pour DSC PowerSeries PC1832 : Manuel d'installation (17 pages), Manuel d'installation (13 pages), Manuel d'installation (20 pages)

Imprimer la page

DSC Power Series PC1616 PC1832 PC1864 System Manual

User Function Commands

First disarm the system then enter [*][6][Master Code]. The[*][6] command is used to gain access to the

following list of Master functions of the system.

1. Time and Date - Enter four digits for 24 Hour System Time (HH-MM). Valid entries are 00-23 for

the hour and 00-59 for minutes. Enter six digits for the Month, Day and Year (MM-DD-YY).

2. Auto-Arm Control - Pressing [2] while in the User Function menu will enable (three beeps) or

disable (one long beep) the Auto-arm feature, by partition. With this feature enabled, the panel will

automatically arm in the Away mode (Stay Away zones active) at the same time each day. The auto-

arm time is programmed with the [*][6][Master Code][3] command.

3. Auto-Arm Time - The system can be programmed to arm at a programmed time each day, per

partition.

Upon entry of this section, enter 4 digits for the 24-hour Auto-arm time for each day of the week.

At the selected auto-arm time, the keypad buzzers will sound for a programmed amount of time

(programmable by the installer only) to warn that an auto-arm is in progress. The bell can also be

programmed to squawk once every 10 seconds during this warning period. When the warning

period is complete, the system will arm with no exit delay and in the Away Mode.

Auto-arming can be canceled or postponed by entering a valid access code only, during the

programmed warning period. Auto-arming will be attempted at the same time the next day. When

the auto-arming process is canceled or postponed, the Auto-arm Cancellation Reporting Code will

be transmitted (if programmed).

If arming is inhibited by one of the following, the Auto-arm Cancellation transmission will be

communicated.

AC / DC Inhibit Arm

Latching System Tampers

Zone Expander Supervisory Fault

4. System Test - The system's Bell Output (2s), Keypad Lights and Communicator are tested.

5. Enable DLS/Allow System Service - If enabled, the installer will be able to access Installer

Programming by DLS. In case of DLS access this provides a window where rings will be detected by

the panel. The DLS window will remain open for six hours, during which time the installer will be

able to enter DLS an unlimited number of times. After the six-hour window has expired, Installer's

Programming will be unavailable again until the window is re-opened.

6. User Call-Up - If enabled by the Installer, the panel will make 1 attempt to call the downloading

computer. The downloading computer must be waiting for the panel to call before downloading can

be performed.

7. Music Input On/Off - If enabled on the PC5936 Audio Interface Module, the user can turn

https://alpha.adt.com/help/61[11/12/2018 9:40:17 PM]