FoxESS LV5200 Manuel de l'utilisateur - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} FoxESS LV5200. FoxESS LV5200 20 pages.
Également pour FoxESS LV5200 : Manuel de l'utilisateur (16 pages)

Imprimer la page

STEP D

Plug the power line of the parallel battery into the remaining output socket, insert the communication line

of the parallel battery into LinkPort0, and lock the ground nut.

STEP E

Repeat STEP C through STEP D to insert more batteries (up to 12 batteries).

6.5 System Start up

· When connected to the inverter, turn on the battery first to ensure that the battery voltage output is

normal, then turn on the inverter.

· All installation and operation must comply with local electrical standards.

· Check all power cables and communication cables carefully.

Turn on the POWER switch

Dial address selection

Definition of address switch for parallel batteries: When the battery pack is connected with multiple

batteries in parallel, the address switch can be used to distinguish different pack addresses. The

hardware address can be set by the address switch on the board. Addresses 1, 2, 3, and 4 represent the

online number of batteries (only the host needs to be configured), 5, 6, 7, and 8 represent the slave

address. The slave address needs to be continuous, and can support up to 12 batteries in parallel.

Single battery address setting: 0001 0000

Parallel batteries address setting: refer to the table below for the definition of address switch.

For example, three batteries are in parallel, and the address switch example is as follows:

Master dial: 0011 0000, slave 1 dial: 0000 0001, slave 2 dial: 0000 0010