DSC TL280R Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} DSC TL280R. DSC TL280R 16 pages. Internet alarm communicator - international
Également pour DSC TL280R : Manuels d'installation (17 pages), Manuel d'installation (16 pages)

Imprimer la page

Installing Ethernet Communicator in Panel

d. Attach the other end of the PC-LINK cable to the communicator (red wire goes on the right-

hand pin of the communicator PC-LINK header (see Figure 3)).

e. Using light pressure (finger tight only), attach the supplied white quad band whip antenna to

the threaded antenna connection point at top of the panel.

WARNING! - Modules are power limited. Do not route any wiring over the circuit board.

Maintain at least 1in. (25.4mm) separation between circuit board and wiring. A minimum

of ¼ in. (7mm) separation must be maintained at all points between non-power limited

wiring and power limited wiring.

3. To electrically connect the communicator to the panel, perform the following steps (see Figure 3).

a. Disconnect both AC power and battery connections from the panel, and disconnect tele-

phone line.

Figure 3: Communicator Wiring Diagram

Input Ratings:

+10.8V ~ +12.5 VDC

100mA

DSC Panel min. power requirements:

- 16.5 VAC 40 VA transformer;

- 12 VDC 7Ah battery

HS2016/2032/2064/2128

AC AC

AUX+

4. Install the RS-422 connections (R models only). When installing the communicator for use

with 3rd party applications an RS-422 cable must be connected between the 3rd party device

and the communicator module. Maximum cable length for RS-422 cable is 1,000 ft. (305 m).

NOTE: Please refer to the installation manual for the 3rd party device for wiring instructions.

Wire the RS-422 connections as per the table below:

NOTE: The GND connection is optional. DSC recommends connecting GND wire at both ends.

Install Network Cable

1. Route the CAT 5 Ethernet cable through back of the panel and plug it into the communicator's

RJ45 jack.

2. Perform the following steps for initial power on of the panel with communicator installed:

a. Reconnect the AC power, telephone line, and battery + connector to the panel.

(The communicator and panel will power up together).

b. Observe that the communicator's red and yellow LEDs are flashing together while it initial-

izes. The red and yellow LEDs will continue to flash until the communicator has success-

PCLINK_2

UA621

RS-422

To 3rd party device

PGM1

PGM3

Z1 COM Z2 Z3 COM Z4 Z5 COM

PGM2

PGM4

Table 3: RS-422 Connections

3rd Party Device

TX+

TX-

RX+

RX-

GND (Optional)

Internet Alarm Communicator Installation Guide

TL280(R)

DSC

UA601

PC-LINK

Red

Z6 Z7 COM Z8

RING

TIP

T-1

R-1

Communicator

RX+

RX-

TX+

TX-

GND

AUDIO/DEFAULT

Jumper pins 4 and 5

to reset.

Network Link

YELLOW

RJ-45

COM

From NID

TL2803G(R)

Use only CAT5

Supervised

Maximum cable length

100 m (328 ft)