DSC LCD 5500 Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DSC LCD 5500. DSC LCD 5500 17 pages. Security station for power 832 security system
Également pour DSC LCD 5500 : Manuel d'instruction (20 pages)

Imprimer la page

Arming

If this display is showing, check to see that all zones are secure by closing all

doors/windows and stopping motion in areas covered by motion detectors. If a

zone will not clear, it may be bypassed to allow partial arming. NOTE: : A

bypassed zone reduces your protect/on. If a zone cannot be cleared, call

your Installer for service.

If this display is showing, check to see that the system is clear of troubles and

that there are no zones bypassed. The system may be armed with zones

bypassed and/or trouble conditions present but to do so will compromise

protection. Check to see which zones are bypassed and that these zones are

intentionally bypassed. If a trouble is present, see the section "Viewing Trouble

Conditions".

If this display is showing, there are no troubles or bypassed zones and the

system may be fully armed. To arm the system, enter your four digit security

code. The keypad sounder will beep as each digit is entered. If the security

code was incorrectly entered, the keypad sounder will beep steadily for two

seconds and the display will not change.

Once the correct security code has been entered, the display will be as shown.

Exit the premises through the door indicated by your installer as the "exit-entry"

door. Once the "exit" delay expires, the system will be armed and will display the

following message:

If you enter your security code with one or more zones bypassed, the following

message will appear as soon as you enter the first digit.

If this message appears, ensure that the zones bypassed are intentionally

bypassed.

If you enter your security code and a system trouble is present, the following

message will appear as soon as you enter the first digit.

If this message appears

service. See the section "Viewing Trouble Conditions".

If you arm the system with a zone bypassed or with a trouble present, your security protect/on

is reduced.

"At-Home" Arming

If you arm the system as described above and do NOT exit the premises, the system will, after the

"exit" delay, arm with interior zones bypassed IF those interior zones have been programmed as

"Home/Away" zones. If you exit during the exit period, ALL zones not intentionally bypassed will arm.

If you enter [

] [9] before your 4 digit security code, the entry delay on the designated "entry-exit"

door is removed so that anyone entering while yo

[

] [9] to arm also allows YOU to exit during the exit delay period and automatically bypasses the

interior zones designated as "Home/Away".

check to see what the trouble condition is and call for

are at home will sound an immediate alarm. Using