Foxpro Cabela's SLP Predator Call Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Foxpro Cabela's SLP Predator Call. Foxpro Cabela's SLP Predator Call 12 pages. Predator caller

Imprimer la page

wire is not connected to the harness, connect it now before attempting to use it. After it's

connected, secure the FOXJACK 4 back to the predator call.

Connect the bird topper to the top of the support rod. The bird topper has a circular coupler

which slips down over the tip of the rod.

Insert the base of the support rod into the coupler inside the top of the FOXJACK 4. This is a

magnetic connection and you should feel it lock into position when inserted. Slide the plastic

grommet into the circular opening on top of the FOXJACK 4.

Operating the FOXJACK 4 Decoy:

Turn on the Cabela's SL

Turn on the TX35 remote control.

Set the slide-switch on the FOXJACK 4 Decoy to your desired position ("on" or "on w/ light"). For

daytime operation, using the "on" position is preferred. For nighttime operation, you may opt to

use "on w/light" to provide subtle illumination of the decoy to help the predators see it.

The FOXJACK 4 motion can be activated by a single push of the "AUX" button on the TX35

remote control. To stop the motion, simply push the "AUX" button again. Each time you push the

"AUX" button, the FOXJACK 4 reverses its current state of operation.

To power-off the FOXJACK 4 Decoy, position the slide switch in the "off" position.

3. Auxiliary Jack Function

The Cabela's SL

Game Call is equipped with an auxiliary jack labeled "AUX". The purpose of this jack is to

allow for the connection of an approved device (such as the FOXPRO Jack Daddy and Jack Junior Decoy) and

to turn it on and off with the TX35 remote control. There are some strict electrical limits involved with this

jack. If these limits are exceeded, damage to your Cabela's SL

covered by the warranty. The electrically inclined will want to know that the jack is connected to the drain

of an internal Field Effect Transistor with a maximum current rating of 10mA. The "tip" polarity of the

3.5mm jack is positive, while the sleeve is negative. If the external device is connected with the polarity

reversed, an internal protection diode within the FET will conduct, causing the device to stay on constantly.

The maximum voltage applied to this jack must never exceed 15 volts. Typical uses for this jack would be to

control a FOXPRO decoy. Instructions on connecting various devices to the "AUX" jack are beyond the scope

of this manual. You are urged to seek help from a knowledgeable professional before connecting any

unapproved device to this jack. Remember that damage to your Cabela's SL

use of the "AUX" jack is not covered by the warranty, nor will FOXPRO

connected to this jack.

4. External Speakers

The Cabela's SL

Game Call is equipped with 2 external speaker jacks which allows you to connect up to 2

additional speakers. The internal speakers perform admirably; however, you may encounter situations that

require higher volume levels. By connecting a larger and more efficient external speaker(s) to the Cabela's

Game Call, the volume level can be increased significantly.

4-1 Connecting External Speakers

The external speaker jacks on your Cabela's SL

damage, it is recommended to select an external speaker with an impedance rating of 8-ohms (visit your

local Cabela's store to find official FOXPRO external speakers). To connect an external speaker: plug the

connector of the external speaker into one of the external speaker jacks. You will notice that each external

speaker jack corresponds with one of the internal speakers. For example, the internal front speaker and

Game Call.

Game Call accept standard 3.5mm plugs. To prevent

Game Call will result. This damage is not

Game Call caused by improper

be liable for damage to any device