DSC Power Series Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} DSC Power Series. DSC Power Series 14 pages. Neo image sensor
Également pour DSC Power Series : Manuel de référence (2 pages), Manuel (18 pages), Manuel de référence rapide (2 pages), Instructions d'installation (2 pages), Manuel rapide (4 pages), Manuel d'instructions d'installation (11 pages)

RESETTING THE IMAGE SENSOR

There are two ways to reset the Image Sensor:

• Power Cycle – Power Cycle can be done by one of two ways: (1) Take out and reinsert batteries or (2) press and

release the sensor reset button. Only initiate a power cycle if the LED has not been active in the last 10 seconds.

After a power cycle, the Image Sensor will enter sensor power up state followed by the memory check state.

• Network Reset - An Image Sensor must be network reset when it has been previously enrolled on a different panel.

The Image Sensor will indicate that it is enrolled on a panel by blinking green after the memory check. In order to

perform a network reset, press and hold the reset button for a full 10 seconds or until the red LED flashes rapidly.

Release as sobon as you see the rapidly flashing red LED. A successful network reset will result in the LED blinking

https://answers.alarm.com/Installation_and_Troubleshooting/Image_Sensor/DSC_PowerSeries_Neo_Image_Sensor/DSC_PowerSeries_

Updated: Tue, 17 Apr 2018 13:46:31 GMT