AirTight 60403 Manuel de l'opérateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} AirTight 60403. AirTight 60403 4 pages. 12v led digital tire inflator
Imprimer la page
oil and grease. Always use a clean cloth
when cleaning. Never use brake fluids,
gasoline, petroleum-based products, or
any strong solvent to clean the inflator.
• Operate the inflator only with the
attachments that are included.
• USE SAFETY GLASSES. Also use face
or dust mask if operation is dusty.
• Your vehicle's 12 Volt battery must be
fully charged to get the best performance
from your inflator. If your vehicle's battery
is weak, the inflator will not work at its
maximum output level.
• For best results, it is recommended that
FEATURES
• Easy to read illuminated digital display
• Digital pressure gauge let's you set the
desired pressure with the press of a
button
• Long-lasting LED light for night use
switches between white, red and flashing
OPERATING INSTRUCTIONS
1. Confirm that the power button on the
inflator is in the "OFF" (button up)
position.
2. To use the inflation accessories, snap
either piece into the universal adapter
and push the lever to lock into place. The
inflation accessory will fit securely.
3. Plug power cord into 12V DC power
outlet.
WARNING
For use with any 12V DC
power outlet rated 15-Amps or higher. Do
NOT use with older 8-Amp cigarette
lighter receptacles.
4. Insert the appropriate inflation
accessory into the inflatable object (tire,
you operate your inflator with your
vehicle's engine running.
WARNING:
DO NOT RUN VEHICLE
ENGINE INSIDE A CONFINED AREA
SUCH AS A GARAGE as bodily injury or
asphyxiation resulting in death can occur.
ALWAYS ALLOW FOR PROPER
VENTILATION.
• Most vehicle 12 Volt power outlets will
operate with vehicle ignition off; however,
some vehicles require that the ignition be
turned on.
• THIS INFLATOR IS NOT DESIGNED
TO FILL AIR TANKS OR AIR SHOCKS.
red SOS signal for added safety
• 100 PSI Maximum pressure capacity.
• Inflation accessories included
• 25 in. Hose Length.
• 9.2 Ft. Power cord.
football, raft, etc.).
5. Hold the (+) or (-) button for
approximately 5 seconds until the display
flashes. Set the required pressure using
the (+) or (-) buttons, then wait 2-3
seconds. The display will show the
current pressure value to which the
object will be inflated.
6. Push the power button to the "on"
(button down) position for the inflator to
start. When the pressure gauge reaches
the pre-set value, the inflator will
automatically switch off and the display
will show "OFF". Press (M), or (+) or (-) to
restart the compressor after finishing the
inflation of one object.