3monkeez P-3MSS-FVTF Instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} 3monkeez P-3MSS-FVTF. 3monkeez P-3MSS-FVTF 2 pages. Stainless steel knee/foot valve
Également pour 3monkeez P-3MSS-FVTF : Instructions d'installation (2 pages), Instructions d'installation (2 pages)
Imprimer la page
Inconsistent or no water flow
Continuous flow
Button is hard to press
Stainless steel products must be cleaned on a regular basis to maintain the ability to resist corrosion. The surface of stainless steel has a protective
layer that creates a protective shield against oxidisation; which makes it durable and long lasting. Protecting this layer is important to ensure the
longevity of this product.
Cleaning stainless steel products is an easy task when done regularly:
• Clear away all food and water deposits from the surface with a microfiber cloth or soft sponge; don't use abrasive materials as they have a
negative impact on the protective layer
• Once cleared of debris, go over the surface with a food safe stainless steel cleaner, bicarb soda or mild detergent and water. The best chemicals
for stainless steel contain alkaline and don't have chloride in them
• To remove stubborn stains, use a good quality stainless steel cleaner and non abrasive cloth
• Rinse thoroughly with clean fresh water
• Towel dry the product with a soft dry absorbent cloth after cleaning and use. This will prevent mineral deposits building up on the surface of the
product
• Once dry, use a food safe stainless steel or metal polish
• Follow the grain of the metal to ensure the best results and to avoid further damage to the surface
• Always keep the product clean and dry when not in use
• Don't leave anything citric on the product as it can etch the surface over time
• Don't leave soaps and other cleaners on your stainless steel product overnight
• Don't leave damp sponges or cloths on the inside or edge of the product when not in use
TIP - Cleaning your stainless steel equipment after each use as above will ensure the product remains in good condition.
NSW
TROUBLESHOOTING
Check water is turned on.
Possible blockage, remove top assembly and cartridge and clean.
Check hose connections to ensure water flows in the direction of the arrow.
Remove cartridge to check for any damage or obstruction. Clean, re-grease and re-install.
Check water pressure. Maximum water pressure should be 500kPa. If above, install a
pressure reduction valve.
STAINLESS STEEL MAINTENANCE AND CLEANING INSTRUCTIONS
www.3monkeez.com.au
|
ACT
|
VIC
P-3MSSP-FVMTA - Top assembly,
locking nut and cartridge
P-3MSSP-FVTFTA - Top assembly,
locking nut and 18 second cartridge
02 9627 6111
|
TAS
|
SA
|
WA
|
NT
|
QLD