AirTime AT15R Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} AirTime AT15R. AirTime AT15R 2 pages. Airtime at15r wall clock installation instructions

Imprimer la page

Hanging the clock

Secure hanger bracket as shown below and adjust the hanger stud using the jam nuts to

desired height. Place the clock on the hanger stud and secure the captive nut.

Normal Operation

In normal operation the clock listens for a synchronization signal 12 times per day (on even

hours at the 58

operation.

Verifying Reception of Last Signal

Press the A button to verify that the clock received the last transmission signal from the ATX

Series master. The LED on the front will flash Green to indicate that the last transmission

was received successfully. If the LED flashes Red, then the last transmission was not

received. This may indicate the Wall Clock is located outside the transmission area.

Start Reception

Press the B button to manually set the clock to "listen" mode. The green LED on the front of

the clock will flash every 2 seconds. When a signal is received from an ATX series master,

the LED will flash every second. The second hand will stop at 12:00 and the minute and hour

hands will rapidly advance to the correct time. (If no signal is received, then verify that your

ATX Series master is transmitting or move the clock to a different, closer location)

Manual Time Setting

Press the B button for 5 seconds until the second hand stops. Press the A button to advance

the minute hand one minute. Hold the A button to rapidly advance the minute and hour

hands. Press the B button when the hands reach the correct time. The clock will start

normal timekeeping operation.

Lathem and AirTime are registered trademarks of Lathem Time Corporation.

minute between 50

and 59

second). The LED will not flash during normal

Document No: USG0089

Revised: 8-19-2011