ATS ATS-FM-M Manuel d'instruction - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} ATS ATS-FM-M. ATS ATS-FM-M 16 pages.

6. General

Temperature: 0 to 40°C (32 to 101°F)

Pressure: Max. 6.0 bar (85 psi)

Weight: 140 g (5.38 oz)

Accuracy: +/- 10%

Connection: 1/4" NPT male

Materials

Sensor Body: Acetal Copolymer, TICONA M90

Turbine: Acetal Copolymer, TICONA M90

Turbine Shaft: #304 Stainless Steel

O-Ring: EPDM Rubber

Housing: ABS resin

7. Operation Guide

7.1 Install Batteries

Slide off the cover of the battery compartment and insert two (2) AA batteries.

Then slide the cover back.

7.2 Connecting Fitting

ATS-FM-M connectors are 1/4" NPT male.

7.3 Operating

T he ATS-FM-M will automatically turn on when there is water flowing through the

sensor. It will automatically turn off after 10 seconds when there is no water flowing.

7.4 Display and Mode Selection

Press the "DISPLAY" button to turn on the Flow Meter LCD screen.

Press the "DISPLAY" button again to display the accumulated flow

volume (flow totalization) or real-time flow rate.

7.5 Reset

Press and hold the "RESET" button for four (4) seconds,

to reset the total measured volume to zero (0).

7.6 Low Battery Power Alert

When battery power is lower than normal working level,

a buzzer will beep twice and the battery symbol on the screen

will blink to notify users to change the battery. Once the batteries

are replaced, the alert will be turned off. Data will be stored in

memory and restored when the user replaces the batteries.