AirTime ATX6 Manuel d'installation et d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} AirTime ATX6. AirTime ATX6 16 pages. Wireless wall clock transceiver

Imprimer la page
ATX6 Installation and User Guide

Introduction:

Lathem's ATX6 is a Wireless Transceiver that can function in
both "Master" (Primary), and "Repeater" (Secondary) modes.
In "Master" mode, the ATX6 can wirelessly transmit clock
synchronization signals to Lathem AT series Wall Clocks, to other
Lathem ATX-series Transceivers in Repeater mode and to Lathem
RC Series Wall Clocks. It can provide RS485 Wired
synchronization signals to Lathem LTRx-512 and LTR-0 Master
Clocks and to DWA-S Bell Ringers. It can also provide a "Dry-
Contact" closure to synchronize other timekeeping systems.
As a "Master", the ATX6 can synchronize its internal crystal-
controlled Real-Time-Clock to "Atomic" references that include
GPS and Network Time Servers and other system references.
In "Repeater" mode, the ATX6 can receive and synchronize itself
to another ATX series Transceiver in Master mode and re-
broadcast the signal according to the AirTime Protocol, same as
described above in "Master" mode.
The ATX6 can be set to transmit its radio signal at any of several
frequencies at either a 4 Watt or 6 Watt output power level.
With an optional external amplifier the signal can be boosted to
20 Watts.
FCC License
This device requires that an FCC License be obtained. Each
installation of this device will require a separate license. It is the
responsibility of each user of this device to obtain and maintain
the required FCC License. For information on obtaining the
required license contact your distributor or review the
information in the FCC section of the specifications.
Page 1
Specifications
Dimensions
9" H X 5 1/8" W X 3 1/8" D
Weight
3.8 lbs (1.702 kg)
Display
LCD with Time / Status indicators
and 4 LED indicators
Housing
All metal enclosure with grey textured paint.
Line Power
90 to 250vAC, 47 - 63Hz, 10W max
Max Current = 100mA (while transmitting)
Standby Power
BR2325 3V Lithium Battery (included)
o
o
Environment
32
to 130
F (0
20% - 80% Relative Humidity (non-condensing)
FCC
Conforms to FCC Part 15
FCC ID: UP3ATX6
Individual License Required
UL
Mounting
Wall (surface)
Inputs / Outputs 6W UHF radio transceiver via BNC antenna
connector
RS232 via Lathem cable (Part # SAE0370)
through an external Ethernet adapter. (Lathem
part # TXTOSER)
RS485 via UTP (Cat3, CAT5) cable to terminal
block
From: LTR-0, LTRx-512, LTR-GPS
To:
LTRx-512, DWA-S, DDC2/4-RS
Dry Contact Sync-Out (Load: 24VDC max at
250Ma) from terminal block
Dry Contact Sync-In to terminal block
GPS Receiver (Part # ATX-GPS) input via RJ45
jack
ATX6 Installation and User Guide
o
o
to 55
C)
Page 26