Attero Tech CommandHub Manuel de l'utilisateur - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Attero Tech CommandHub. Attero Tech CommandHub 20 pages. Unify proxy device for control and routing

Imprimer la page

4.2.5 – Set Dante Route

This command will allow the 3rd party controller to initiate a Dante route (channel assignment) using the information

retrieved from the other command set. Note, all commands and parameter contents are case sensitive.

Start

Command

Character

(ASCII)

(Hex)

0x02

"SDRT"

Status Byte Return Values:

•

0000 – Error in route set operation, check format and content of message

•

0001 – Set operation sent successfully to Dante API. This does not guarantee that the route was setup,

merely the request was made successfully. To ensure the route has in fact been set up, the control

application should test for a valid route using the GADC command after the SDRT command. This

process is recommended due to the fact that Dante API provides no specifications on the time it takes

for a route to be established.

*Note: Spaces in the examples are for clarity only. Spaces may occur in the message content as part of channel names

but are never used as message delimiters.

Example command:

<START> SDRT unDX2IO-010203<CR> Analog Out 1<CR> Analog In 1@unD3IO-020304<CR> <STOP>

Example response:

Device Name

(ASCII) + <CR>

"unDX2IO-010203"

<CR>

Table 9 - SDRT Command Format

Start

Command

Character

(ASCII)

0x02

RDRT

Table 10 - SDRT Response Format

RX Channel

Assigned Channel

Name (ASCII) +

<CR>

"Analog Out

"Analog In 1@unD3IO-

1"<CR>

Status

Stop

(4 ASCII)

Characters

Represents

value pre-

pended

with '0'

0000

0x03 0x07 0x04

Page 13

CommandHub

User Manual

(ASCII) + <CR>

020304"<CR>

614-00019-01

Stop

Characters

0x03 0x07

0x04