Attic Breeze GEN3 CMD Series Manuel d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Attic Breeze GEN3 CMD Series. Attic Breeze GEN3 CMD Series 4 pages.
Imprimer la page
Step 4 - Mount the Fan
Remove all packaging material and tape from your fan. Position the fan so that it is centered with the vent hole and
allow the control cable to hang freely from the bottom of the fan unit. Locate the control switch (red bag) included
with your solar fan, or if installing a Breeze Mate® control system, please follow the instructions included with that
product at this time. Plug the control switch (or Breeze Mate® cable) into the control cable 4-prong plug. For models
featuring a remote mounted solar panel, plug the power cable from the solar panel into the 2-prong plug on the
control cable.
ATTENTION:
After the control switch is connected, your Attic Breeze solar fan may begin
operating immediately when exposed to sunlight.
Caulk around the top of the roof curb box using the weatherproof sealant and
position the fan over the roof curb (see Figure 3). Align the fan unit with the
vent hole so that the sticker "INSTALL THIS SIDE TOWARDS GROUND" is facing the
correct direction. The fan unit can also be turned 90 degrees from this postion
to allow for better solar panel sun exposure if needed (ex. East or West facing
roof orientation).
With all fan cables connected and hanging inside the roof curb, mount the fan
unit over the roof curb box and flashing, securing the fan to the sides of the roof
curb box using three self-tapping screws per side. Apply additional sealant to
weatherproof the installation as needed.
Adjusting the Solar Panel
The solar panel on your Attic Breeze solar attic fan may either be left down in
the horizontal mounted position as received from the factory, or the solar panel
bracket may be raised to pivot the solar panel toward the south in order to get
better sun exposure.
To raise the solar panel, first loosen the set bolts on the solar panel mounting
brackets using a 7/16" wrench as shown in Figure 4. Raise the solar panel to the
desired tilt angle using the provided adjustment slots and tighten the set bolts.
DO NOT OVER TIGHTEN THE SET BOLTS! You may damage your bracket if
too much torque is applied to the set bolts.
ATTENTION:
area of either Florida or Texas that has been designated as a high velocity
wind zone area. The solar panel must remain in the flat horizontal position
due to building code requirements.
Warranty Registration
Attic Breeze offers an industry leading LIFETIME WARRANTY on your new solar
attic fan. For more information about the terms and conditions of our warranty,
please see our website for details. Thank you for choosing Attic Breeze!
YOUR WARRANTY MUST BE REGISTERED WITHIN 90 DAYS OF
INSTALLATION. Please visit our website at www.atticbreeze.net to
register your warranty.
KEEP THE SOLAR PANEL COVERED DURING INSTALLATION.
Do not raise the solar panel if installing this product in an
www.atticbreeze.net
Copyright © 2021 Attic Breeze, LLC. All rights reserved.
Figure 3 - Mounting the Fan
RAISE SOLAR PANEL
LOOSEN SET BOLTS
Figure 4 - Adjusting the Solar Panel