DSW DSW01 Instructions - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} DSW DSW01. DSW DSW01 5 pages.

Imprimer la page

the connection line between wire detector and general controller should not exceed 3m, and should

install detector out of the way.

OPEN FRONT COVER FIGURE

FRONT COVER

TIGHTEN OFF

SCREW

1. operation: install it out of the door and use it as remote control doorbell, press the key,

general controller will give Dingdong Dingdong to remind host open door. It can not

operate other function of the general controller.

．

Attention: avoid installing the unit on metal base.

4-KEY REMOTE CONTROLLER

1 ． operation

1.1 press the panic alarm key, general controller will give panic alarm and the 8 LEDs on

the left and light all light.

1.2 press time-delay fortify key, general controller will give DI ...

DI ...... , Fortify LED flash once a second, after 60s, it give DI DI DI

then sound stop, it enter fortify state, Fortify LED flash once 2s.

1.3 press quick fortify key, general controller give DI and it enter

fortify state, Fortify LED flash once 2s.

1.4 press cancel key, you can cancel above operation, general

controller give DI DI, that indicate operation has been canceled.

．

Attention: avoid installing the unit on metal base.

WIRELESS DETECTOR DPS-55

sense twice, the sensor emit signal , 15S later after it emit signal,

sense twice again, the sensor emit signal again. This setting

enhance its preventing false-alarm and preventing-pet

function.

2. test

2.1 press the fortify key on 4-key remote controller, set the general controller on fortify state.

2.2 set the jumper on needed position;

2.3 install 9V battery, after 60s the sensor enter stable working state;

2.4 move along the tangent of the lens, sense it, the sense LED light and then it emit signal to general controller, the

emission LED light;

2.5 after receiving emission signal, general controller give alarm(>90db), the alarm time delay is 3Min 30s, provided

that its corresponding channel is channel 3, the Ch3 should light(press cancel key on 4-key remote controller to stop

alarm quickly).

PUSH BACK THE

FRONT FCOVER

PULL UP THE

FRONT COVER

DOORBELL

CONTROLLER

1 ． Jumper setting (like right

figure)

1.1 Sense once to emit:

sense once, the sensor emit

signal , 15S later after it emit

signal, sense once again, the

sensor emit signal again.

1.2 Sense twice to emit:

BOTTOM COVER FIGURE(BACK)

PRESS HIDDEN HOLE WITH POWER TO OPEN

CROSSING-LINE

HIDDEN HOLE

INSTALLING HOLE

REMOTE

EMISSION

LED

BATTERY

COVER

4-KEY REMOTE CONTROLLER

Low-battery LED

Emit LED

DIP switch

CROSSING-LINE

HIDDEN HOLE

INSTALLING HOLE

BOTTOM COVER

INSTALLING HOLE

DOORBELL REMOTE CONTROLLER

PANIC ALARM

TIME-DELAY FORTIFY

QUICK FORTIFY

CANCEL

Jumper

AUTO

Sense LED

PIR

EMISSION LED

EMISSION KEY

Sense

once to

emit

Sense

twice to

emit