DT DT SCREENS Dynamic 2S Manuel d'installation - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} DT DT SCREENS Dynamic 2S. DT DT SCREENS Dynamic 2S 12 pages.
Imprimer la page
Inner Screen Cover Installation
•
Install the bottom covers first. The covers are magnetic and simply align and clip into place
allowing the magnets to 'grab'. The barb on the back of them will slot into the groove on
the aluminium profile just below the grey plastic fabric retaining track. There are two
sections for the top and two for the bottom with a central join. You will need to slide the
outer end in behind the bask bar and you will be able to feel when the magnet has made
contact with the steel plate on the cover
Next install the top sections.
•
If you need to remove the covers at any point, lift up the cover from the edge nearest the
screen fabric and rock up and lift away from the magnets.
Electrical Operation
•
Power on the electrical control panel
The main control screen will be visible on the touch screen once it has booted up.
•
•
To start operation press 'Home' this will set the masks to their home position (just covering
the edge of the screen surface but showing the full width aspect of the screen).
Now press 1.78 this will move the masks to a 16/9 image size.
•
•
Cycle between Home and 1.78 2-3 times just to initialise the masks and ensure that
everything centralises in the mask runners following transit.
If at any time a mask sticks during this initialisation procedure and becomes slack, hit stop
and then manually push the mask bar towards the middle of the screen slightly. This will free it
and continue with the initialisation sequence.
The screen is now ready for operation and external RS232 control of operation.
•
Dynamic 2S Installation Manual – V0.2
11