DT Research DT303CI Manuel d'utilisation de base - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation de base pour {nom_de_la_catégorie} DT Research DT303CI. DT Research DT303CI 4 pages.

Imprimer la page

Peripherals Support

Through its USB ports, the DT303CI supports a wide range of USB-based peripherals.

These peripherals are applicable for software installation, applications storage, data

storage, and system software recovery and updates.

Battery Usage and Maintenance

DT Research tablets and laptops are powered by lithium polymer battery packs in

proprietary form factors. Battery configurations for the DT Research devices include

internal (bridge or backup), removable or swappable implementations.

Battery usage cycles, or duration between necessary re-charge, vary with a number

of factors, including device model, device usage pattern and battery health/aging.

The DTR battery packs may be charged while attached to the device or when sepa-

rated from the device and docked in proprietary battery charging cradles. Following

the guidelines on good practice below can help to keep a battery pack healthy and

prolong battery usage cycles and battery lifespan.

•

Avoid high heat conditions during operation, idle, charging, and storage states.

•

Avoid letting the battery pack remain in very highly charged state or overly

low charged state for extensive periods of time. Keeping the battery capacity

between 30% and 80% of maximum capacity is recommended. The prevailing

battery level(s) can be read from the Battery utility within the Windows operat-

ing system.

•

Avoid letting the battery be over-discharged or depleted. Over-discharge can

occur when a fully-discharged (0% level or thereabouts) battery pack is allowed

to remain in such a state for an extended period of time (weeks or months).

The embedded battery controls enter a protection mode and recharging will be

prevented for safety reasons. To reduce the likelihood of over-discharge, consider

recharging idle batteries regularly to some level between 30%-80% of capacity.

Federal Communication Commission Interference

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the

following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate

this equipment.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

This device and its antenna(s) must not be co-located or operating in

conjunction with any other antenna or transmitter.

This Class [B] digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du

Canada.

Product End-of-Life Notice

For reuse and recycling facilities, please visit below link to get disassembly

instructions:

http://www.dtresearch.com.tw/zh/About/csr.html

http://www.dtresearch.com.tw/EPEAT/DT301Y_Product_End-of-Life_Disassembly_

Instructions.pdf

For the product take-back service information, please visit:

http://www.dtresearch.com.tw/zh/About/csr.html