3onedata IES206G-2GS Manuel d'installation rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} 3onedata IES206G-2GS. 3onedata IES206G-2GS 2 pages. Unmanaged industrial ethernet switch
Également pour 3onedata IES206G-2GS : Manuel d'installation rapide (2 pages)
Imprimer la page
comes with the device is installed firmly.
Step 2
Insert the bottom of DIN-Rail mounting kit (one side
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Step 3
Check and confirm the product is firmly installed on
DIN-Rail, and then mounting ends.
【Disassembling DIN-Rail】
Step 1
Power off the device.
Step 2
After lift the device upward slightly, first shift out the
top of DIN-Rail mounting kit, and then shift out the
bottom of DIN-Rail, disassembling ends.
Attention before powering on:
Power ON operation: first connect power line to the
connection terminal of device power supply, and then
power on.
Power OFF operation: first unpin the power plug, and
then remove the power line, please note the operation
order above.
【Power Supply Connection】
DC power supply
The device provides 4 pins power
supply input terminal blocks and
two independent DC power supply
systems of PWR1 and PWR2. The
power supply supports nonpolarity
and anti-reverse connection. It can normally operate after
reverse connection. Power supply range: 24VDC (12 ～
48VDC)
【Checking LED Indicator】
The function of each LED is described in the table as below:
LED
Status
Description
PWR1 is connected and running
P1
ON
normally
PWR1 is disconnected and running
OFF
abnormally.
PWR2 is connected and running
ON
normally
P2
PWR2 is disconnected and running
OFF
abnormally
ON
Ethernet port connection is active.
Link/ACT
(G1-G2,
Blinking
Data transmitted
1-4)
OFF
Ethernet port connection is inactive.
【Specification】
Panel
Gigabit SFP
1000Base-SFP, SFP slot
10/100/1000Base-T(X)
self-adapting RJ45 port, full/half
Gigabit copper port
duplex mode, support MDI/MDI-X
self-adaption
Power indicator, interface
Indicator
indicator
Exchange attributes
Backplane bandwidth
12G
Packet buffer size
1Mbit
MAC table size
1K
Power supply
24VDC (12~48VDC)
Support dual power supply
Input power supply
redundancy, nonpolarity and
anti-reverse connection
4 pins 7.62mm pitch terminal
Access terminal
blocks
Consumption
No-load
1.44W@24VDC
Full-load
4.34W@24VDC
Environmental
Limits
Working temperature
-40~75℃
Storage temperature
-40~85℃
Working humidity
5%~95% (no condensation)
Protection grade
IP40 (metal shell)