BOUNCE IMAGING Recce 360 mini Manuel d'utilisation - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} BOUNCE IMAGING Recce 360 mini. BOUNCE IMAGING Recce 360 mini 18 pages.
Imprimer la page
Operating Manual - Recce 360 mini (V2.0 20220524)
Check: Power up the camera and connect to it from the app. Point the suspected imager
boundary at an object approximately 2..3 meter (6..12 ft) away from the camera. Check if there
is no significant ghosting/overlap of the object on the boundary.
If this resolves the ghosting/overlap, the camera is functioning as expected. Due to the used
optics and algorithms, the boundary between imagers is an approximation of reality. This causes
objects that are very near to the camera to not properly align. Note that despite the
misalignment, it is very improbable that near objects disappear. This might only happen with
very small objects that are very near to the camera.
If this does not resolve the problem, it is likely the camera has taken a big impact and needs to
be recalibrated at the factory. There is little that can be done about this in the field.
6.5 Audio quality
Symptom: Clicking noise audio from the camera (camera microphone)
Check: Clicking noise can be caused by the inductors driving the illumination LEDs if the
illumination mode is in flash mode. This is inherent to the camera design and cannot be
changed. A solution might be to disable the illumination LEDs or to change to a continuous
illumination mode (available on selected cameras).
Symptom: Bad audio from the camera (camera microphone)
Check:
1. Verify if the audio grid (bottom view - A) is not blocked.
2. Ensure the camera can be properly charged (see sections 3.2 and 6.1). Connect from
the receiving device to the camera.
3. Verify if the audio is not muted and the playback volume on the receiving device is set to
max. Try another receiving device or camera to compare.
4. If the audio quality issue is not resolved, try again in an area with little wifi interference.
Symptom: Bad audio to the camera (camera speaker)
Check:
1. Verify if the audio grid (bottom view - A) is not blocked.
2. Ensure the camera can be properly charged (see sections 3.2 and 6.1). Connect from
the receiving device to the camera.
3. Verify if the microphone on the mobile device is not obstructed or blocked.
4. Playback a pre-recorded audio sample to the camera (like the siren). This sample has a
known good signal amplitude. If it doesn't sound good there might be a problem with the
speaker.
5. If the audio quality issue is not resolved, try again in an area with little wifi interference.