AdDent Calset Mode d'emploi - Page 2
Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} AdDent Calset. AdDent Calset 2 pages. Composite warmer
Imprimer la pageoperatIon of calset
Plug the universal power supply into a suitable outlet. Connect the power plug into the
power connector MaKInG sUre tHat It Is fUlly seated. Put a gun dispenser,
syringe, anesthetic, or porcelain tray on top of the heater. The following is a list of the
push button switch functions with regard to temperature and LED color indicators.
The push button will scroll through three temperatures as follows:
push Button
led color
Push 1 time
Green
Push 2nd time
Orange
Push 3rd time
Red
Hold for 2 seconds
―
The amber (yellow) LED on the right side of the unit turns on when the switch is
depressed. This indicates that the wall plug and power plug are properly connected
to the unit. In approximately 14 minutes the desired temperature is reached and the
LED stops flashing.
over teMperatUre
The Calset has a back up thermostat that will shut down the Calset if the temperature
exceeds the program value. The lights will go out and the unit will cool down. When
the thermostat resets, it may be possible to re-energize the Calset, but if it shuts down
again, return the Calset for repair.
!
disinfection
The Calset unit can be disinfected to prevent cross contamination. The
top tray is autoclavable, or can be wiped with a cloth and disinfectant. The plastic
housing should only be wiped using a disinfectant and should not be sprayed. do
not aUtoclave tHe BottoM HeatInG tray.
!
caution
The Calset operates Hot. Care should be taken to avoid touching hot
surfaces. The tray has a plastic cover and plastic rings for handling. If the tray is to be
taken off the control housing, the heater should be turned off so that the top plate will
cool. This is achieved by holding the control switch in for 2 seconds until amber light
goes off. The unit will then turn off and the top plate will cool.
temperature
98°F (37°C)
130°F (54°C)
155°F (68°C)
Turn Off
accessory trays
tri-tray – Holds dispenser gun and 2 finishing instruments. For use with CoMax
(AdDent), Caulk, Kerr (original model), SDI, and Clinicians Choice
dispenser Gun trays ― for use with 3M, Kuraray, Vident, Centrix Nu-Gun and
Vivadent Guns. Visit website for PN's. www.addent.com
anesthetic tray – Holds 3 anesthetic carpules. For use only with 98°F (37°C)
Temperature setting (Green LED).
porcelain veneer tray – To cement veneers with composite
syringe tray – For composite syringes
trI-tray GUn tray
Use of trI- tray
When placing the composite compule
gun into the opening for heating, be sure
the groove at the top of the sleeve lines
up with the orifice of the compule in the
dispenser gun.
your favorite composite
finishing instruments
Spare Compules
LED Indicators
!
dIsInfectIon InstrUctIon for dIspenser GUn tray
To clean, remove the plastic sleeve and top. The sleeve and the top can be
cold sterilized. The metal tray can be autoclaved or cold sterilized. A Q-tip with
disinfectant can be used to clean out the middle of the tray.
!
do not aUtoclave tHe BottoM HeatInG tray