Atwood 493433 Installation Fonctionnement et entretien - Page 2

Parcourez en ligne ou téléchargez le pdf Installation Fonctionnement et entretien pour {nom_de_la_catégorie} Atwood 493433. Atwood 493433 7 pages. Bike rack for recreational vehicle ladder

Imprimer la page

Before you begin...

MAY CAUSE PERSONAL INJURY OR PROPERTY

DAMAGE

It is the responsibility of the installer to inspect the

permanently mounted RV ladder to determine its

condition, installation, and rated capacity will allow the

use of this Bike Rack. Seek a qualified technician to

determine if your permanently mounted RV ladder is

installed properly and is fit for use with this Bike Rack.

Ladder Specifications:

-The ladder should be of a minimum 1" diameter

aluminum or steel tubing common design with steps at

least 1-3/4" wide.

-The ladder should be of a common design with spacing

between the vertical rails of at least 9".

-The ladder should be securely mounted.

-The ladder should have a minimum rated capacity of

150 pounds.

-The ladder should be in good condition with no dented,

cracked or rusted parts.

MAY CAUSE PERSONAL INJURY OR PROPERTY

DAMAGE

Become familiar with the Superlock strap buckle to

make sure all of your straps are threaded properly.

When threaded properly, the strap will allow you to

adjust and tighten as necessary (See Diagram #2). If

threaded improperly, the strap buckle will slip and the

strap will loosen.

Refer to Diagram #2 showing how the buckle is to be

threaded. The Superlock buckle requires the strap to be

straight in the section it is applied in order to apply

proper locking force within the buckle; NEVER use the

Superlock buckle on a curved section of the strap.

CAUTION

In all cases, after threading the buckle and installing

each strap, make sure all straps are pulled tight.

INSTALLATION

How to mount the Bike Rack to your permanently-

mounted RV ladder.

MAY CAUSE PERSONAL INJURY OR PROPERTY

Install at a height sufficient for the mounted rack to

have adequate clearance from the lowest point of the

bike to the road surface. Verify the loaded bike does

not extend past the side of the RV or cause any

interference and/or obstruct the driver's view.

1. Determine the appropriate rung of the ladder to mount

to, normally the step immediately above the ladder's

support standoffs, approximately the 4th step up. Install

the Atwood Bike Rack onto the ladder following the

steps pictured below.

CAUTION

DAMAGE