ATX DYNANO2E Manuel d'installation et d'utilisation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} ATX DYNANO2E. ATX DYNANO2E 18 pages. Dvis series nano-sized digital video insertion system rf output

Imprimer la page

FIRMWARE UPGRADE INSTRUCTIONS

4.
Firmware Upgrade Instructions
The following procedures provide detailed instructions for upgrading DVISn firmware. They require a self-installing firmware
file supplied by ATX and a laptop or desktop PC running any OS supporting a web browser with available Ethernet connection
(called the "management computer" in the following procedures). They also assume that the DVISn has been installed and is
operating properly.
4.1

Save Firmware Update to PC

Save the firmware update file in a convenient location on the management computer. This file is in .tgz format and contains
the version code for this update (at publication date, the version code is 0.998).
4.2

Connect PC to DVIS/DVISn

Set appropriate network parameters on the management computer in order to access the DVIS remote management interface.
For example, if the network address for the DVIS/DVISn is set to the factory default setting (192.168.0.23) and you are using
a Windows based PC:
1.
Set the management computer's Ethernet interface to a static IP address on the 192.168.0.x subnet.
a)
From the Control Panel, open Network Connections and select the connection associated with the Ethernet
adapter to be used for connecting to the DVIS/DVISn (e.g., Local Area Connection).
b)
Right click on the connection and select Properties.
c)
Select Internet Protocol (TCP/IP) and click Properties.
d)
Click the selection box beside Use the following IP address to enter a check mark in the box.
e)
In the IP address field, enter 192.168.0.x (where x represents any number from 1-253 except 23).
f)
In the Subnet mask field enter 255.255.255.0.
g)
Click OK and then OK again in the previous window.
2.
Connect the management computer's Ethernet adapter to the DVIS/DVISn Ethernet port using a CAT5e crossover
cable (supplied with the unit).
3.
On the management computer, open a web browser and enter http://192.168.0.23 in the address field.
5.
The DVISn Settings screen appears.
4.2.1
Upload Firmware to DVISn
1.
In the DVISn Version Update box, click Browse, navigate to the location of the saved .tgz file and click Open. The
file name and location appear in the DVIS Version File selection box.
3.
Click Update to begin uploading the file to the unit. A progress bar indicates the percentage completion (0 to 100%).
MDU Solutions
– DVIS Nano - Nano-sized Digital Video Insertion System RF Output – Installation & Operation Manual
®
CHAPTER 4: FIRMWARE UPGRADE INSTRUCTIONS
4-1