ATZ HDBaseT HDBT-E150B-18 Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ATZ HDBaseT HDBT-E150B-18. ATZ HDBaseT HDBT-E150B-18 12 pages. 1x8 splitter hdmi 2.0b, hdr10+, 18g, support 4k@60hz (150m) c/w 8x receivers

Imprimer la page
Model
: ATZ HDBT-E150B-18
Description: HDBaseT™ 1x8 Splitter HDMI 2.0b, HDR10+, 18G, support 4K@60hz
(150m) c/w 8x Receivers
Rear Panel:
No. Name
1
EDID DIP
switch
2
RS-232
3
IR IN
4
IR OUT
5

AUDIO OUT

(COAX, L/R)
6
HDMI port
7

HDBT OUTPUT

port (1~8)
8
Connection
Signal Indicator
lamp (Green)
Data Signal
9
Indicator lamp
(Orange)
10
DC 24V
11
POWER switch Press this switch to power on/off the device.
Notes
: - All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only. Photo attached is for reference only, it may be slightly varied in items of colour, shape from the actual item delivered
from time to time.
Function Description
Used to set EDID mode. Please refer to Section "6. EDID
Mode" for details.
Connect to a PC or control system via a 3-pin phoenix
connector cable for three functions:
1, Firmware update;
2, Control the Splitter via RS-232 commands;
3, RS-232 signal pass-through (from transmitter to
receiver or from receiver to transmitter).
Connect to IR receiver cable, the IR receive signal will
emit to "IR OUT" port of the HDBaseT Receiver.
Connect to IR blaster cable, the IR emit signal is from "IR
IN" port of the HDBaseT Receiver.
Coaxial/balanced audio output port, connect to amplifer or
speaker.
IN: HDMI input port, connect to HDMI source device such
as DVD or set-top box with an HDMI cable.
LOOP OUT: HDMI loop output port, connect to the HDMI
display device such as TV or Monitor with an HDMI cable.
Connect to the HDBT IN port of the HDBaseT receiver
with a CAT cable.
Illuminating: Transmitter and Receiver are in good
▪
connection status.
Flashing: Transmitter and Receiver are in poor
▪
connection status.
Dark: Transmitter and Receiver are not connected.
▪
Illuminating: HDMI signal with HDCP.
▪
Flashing: HDMI signal without HDCP.
▪
Dark: No HDMI signal.
▪
Plug the DC 24V power supply into the unit and connect the
adaptor to an AC outlet. (Note: The transmitter can power
the receiver via a CAT cable.)
pg. 4
All specifications are subject to change without prior notice.
© Copyright ATZ