ABSTRACT ClubColour Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} ABSTRACT ClubColour. ABSTRACT ClubColour 19 pages.

Abstract Universal Instruction Manual

Dip switches. Dip switches 1-9 set the DMX channel that the unit will respond

to (in binary code). Channel 1 is the first valid DMX channel. If all switches 1-9

are off, the unit will automatically set its own DMX channel. Switch 10 sets the

stand alone 'group' of the unit, either 1 (off) or 2 (on). See the last page of this

booklet for help on setting the switches.

Microphone. The unit can sense the beat of the music through this built-in

microphone.

Mains power (not shown in picture). Power is supplied to the unit through an

IEC connector on the back face of the unit. There is a power supply fuse built

into this connector. If this fuse fails you should take the unit to an Abstract

dealer for service.

Futurescan 1, Gladiator Revolution and DuoColour have captive power

leads.

Lamp alignment (not shown in picture). "Club" effects only. On the bottom of

the unit (the opposite end from the mirror) there are 3 screws marked "Lamp

align". These allow you to adjust the position of the lamp within the reflector to

optimise the evenness of the light beam.

The alignment is set at the factory and you should not need to change it unless

you renew the lamp.

Focus (not shown in picture). You can focus the light beam for sharp gobo

projection by turning the lens. If you turn the lens anticlockwise several turns,

the lens will come out of the unit allowing it to be cleaned.

On the Twister 4 and Galactic Star, there is a slider knob on the top of the case.

Turn the knob anticlockwise to loosen it, focus by sliding backwards and

forwards, then turn the knob clockwise to lock the focus position.

10.

Remote control socket (Futurescan 1, Gladiator Revolution and

DuoColour). The "remote control" (3 buttons) can be connected to this socket

using a stereo jack cable. Do not connect any other equipment to this socket or

damage may result.

Note: when power is not connected to the unit, the DMX input and

Page 4

output connectors are bridged through by a relay to maintain

the DMX circuit.