AU Optronics BenQ PM096BW0 Manuel d'installation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AU Optronics BenQ PM096BW0. AU Optronics BenQ PM096BW0 20 pages. Solar photovoltaic modules
Imprimer la page
Chapter 3 Mo
Chapter 3
Chapter 3
Chapter 3
Mo
Mounting
Mo
unting Guidelines
unting
unting
Modules may be mounted at any angle from horizontal to vertical. Select the appropriate
orientation to maximize sunlight exposure.
A gap between the module and system structure or ground is required to prevent wire
damage and to allow air to circulate behind the module.
Take care to follow all applicable regulations, especially municipal and fire codes, when
planning and executing your installation. Do not remove or alter the module frame.
Additional mounting holes may damage the module and reduce the strength of the frame.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
Modules should only
Modules should
only be mounted u
Modules should
Modules should
only
only
mounting instructions below could
mounting instructions below
mounting instructions below
mounting instructions below
3.1 Mounting with Screws
• Secure the module to the structure using only the factory drilled mounting holes.
• Do not drill any additional holes in module frame (doing so would void the warranty).
• Use corrosion-proof fastening materials.
• A torque wrench must be used for assembly. In the examples shown, the tightening
torque must be 20N．m.
• Refer to product datasheet for the module dimensions and mounting hole locations.
PM200M00 / PM245P00 / PM250M01 / PM300P00
PM200M00 / PM245P00 / PM250M01 / PM300P00
PM200M00 / PM245P00 / PM250M01 / PM300P00
PM200M00 / PM245P00 / PM250M01 / PM300P00
Secure the modules to the structure using four stainless steel bolts, with nuts, washers, and
lock washers. Only the existing mounting holes (Diameter: 9mm
to meet 5400Pa design strength under IEC 61215/ IEC 61730 and to meet 2400Pa design
strength under UL 1703.
PM318B00 / / / / PM318B01
PM318B00
PM318B00
PM318B00
PM318B01
PM318B01 / / / / PM096B00
PM318B01
Secure the module to the structure using four M6 (¼")
washers, and lock washers per module. Only the mounting holes that are 322mm from the
short end of the module can be used for the module to meet 5400 Pa design strength.
2013/7/25
Guidelines
Guidelines
Guidelines
be mounted using
sing one of
one of the following methods
be mounted u
be mounted u
sing
sing
one of
one of
could affect max wind load and/or product warranty.
affect max wind load and/or product warranty.
could
could
affect max wind load and/or product warranty.
affect max wind load and/or product warranty.
PM096B00
PM096B00
PM096B00
the following methods. . . . Deviating from the
the following methods
the following methods
9mm) that can be used for module
9mm
9mm
M6 (¼") stainless steel bolts, with nuts,
M6 (¼")
M6 (¼")
8
Deviating from the
Deviating from the
Deviating from the