CON-TEC CTL-135 Manuel

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CON-TEC CTL-135. CON-TEC CTL-135 2 pages. Manual dynamo led rear light

Manual Dynamo
LED Rear Light
CTL-135
Congratulations on the purchase of your new device. The user's manual is part of this device and
contains important information to safety, installation and disposal. Familiarize yourself with all
operating and safety instructions before using the device. Use the device as described and in the
specified areas of application. Keep this manual in a safe place and have it with you when using the
device.
Used symbols
Green Point – Recycling the packaging
Symbol for the detection of electrical and electronic devices
Test mark of the Federal Motor Transport Authority (K with
K XXXX
the following approval number)
Proper use
The product is intended for use on bicycles with pedal assistance and serves the illumination of the
road. This LED front light is approved according to the currently valid RTLR (StVZO). The product is
intended for outdoor use.
WARNING! LIFE AND ACCIDENT HAZARD FOR INFANTS AND CHILDREN!
Never leave children unattended with the packaging material, because of suffocation danger by
swallowing packaging parts. Always keep the device away from children. The device is not a toy!
This device can be used by children of age 8 and over and by persons with reduced physical or
mental capabilities or lack of experience and knowledge if they have been supervised or
instructed concerning the safe use of the device and by understanding resulting hazards. Children
are not allowed to play with the device. Cleaning and user maintenance should not be carried out
by children without supervision. Do not disassemble the device. Improper repairs can cause
significant risks for the user. Only have repairing made by qualified personnel.
Safety information
- Do not look into the LEDs of the front
- Do not point the LED front light directly at people or animals.
- The light beam of the LED front light must point straight in direction.
- The light distribution may be obscured by no other attached parts or pieces of luggage, not even
partially.
- The LEDs are not interchangeable. If the LED fails, the entire luminaire must be replaced.
- The front light or the rear light may only be mounted on bicycles with an AC power supply
- Please note that the DC version may only be used on bicycles with electric pedal assistance. If, after
the support drive has been turned off due to discharge
- an uninterrupted power supply to the lighting system is still ensured for at least two hours after the
support drive has been turned off due to discharge, or if the drive motor can be used as an alternator
on a transitional basis in order to continue to supply power to the lighting system.
Manual_TL-135
LED rear light and rear reflector
1
2
3
4
5
Mapped components
Rear light
1
2 LEDs rear light
2
Integrated rear reflector
3
Mounting screws
4
Cable connection for dynamo
5
LED rear light assembly
Mount the rear light (1) to the carrier. Use the included screws and nuts.
Connection to the E-bike system
On the back of the rear light (1) is the contact plug (5) for connection to the light system. Plug the non-
insulated line ends onto the contacts according to the polarity.
Black cable = power
Black-white cable = earth
Rear light adjustment
Reference axis
90 °
Front
Attention:
Regularly check the correct setting and mounting height of your rear light. The rear light must be
mounted in a range from 250 to 1200 mm above the ground. It must be mounted and adjusted so
that the reference axis is parallel to the vehicle longitudinal mid-plane and parallel to the road surface
(see figure). Tail lamp(s) and front light may only be switched on together if they are operated by a
light engine.
Back
Reference axis
90 °