daltile 828 BrS Manuel d'utilisation - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} daltile 828 BrS. daltile 828 BrS 16 pages. Tile saw
Imprimer la pageSingle Step Cutting
DO NOT FORCE THE TOOL! It will do the job
better and safer at the rate for which it was
designed.
Use original Daltile
®
wet cutting blades only.
Loosen the Adjustable Cutting Guide
retaining knob.
Retaining Knob
Position the Adjustable Cutting Guide to
desired cutting length.
Tighten the retaining knob.
Place the tile against the Ruler/Stop
and Cutting Guide.
Turn the motor ON.
Verify proper coolant flow on both sides of
the blade.
Perform the cut.
Turn the motor OFF when work is
complete.
Multiple Step Cutting
During this sawing process the saw is positio-
ned at the desired height and moved back and
forth through the material to be cut until after a
number of steps it is completely cut through.
Place the material to be cut on the sawing
table and position against the fixed stop
and eventually the adjustable stop.
PAGE 14 DALTILE 828 BrS OPERATING MANUAL V02/2004R1
OPERATING INSTRUCTIONS
Cutting Guide
Position the cutting head at the desired
height
Hold the material with one hand while
making sure your hand is free from the
cutting blade.
Perform the cut. This process must be
repeated until the material has been
totally cut through.
Turn the motor OFF when work is
complete.
45˚ Miter Cutting:
The Daltile® 828BrS Tile Saw is designed to
perform 45˚ Miter Cuts without additional tools.
Loosen the 2 handles on either side of the
machine.
Tilt the cutting head into the 45˚ position.
Fasten both handles.
Place the tile on the cutting table in the
desired position.
Hold the tile down with one hand. (Keep
hand away as far as possible from the
cutting blade)
Turn the motor ON.
Verify proper coolant flow on both sides of
the blade.
Perform the cut.
Turn the motor OFF when work is
complete.