Conair 276 Manuel d'instruction et de stylisme
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et de stylisme pour {nom_de_la_catégorie} Conair 276. Conair 276 2 pages. Volume boost
IMPORTANT SAFETY
the appliance to a Conair service center for
examination and repair.
INSTRUCTIONS
5. Keep the cord away from heated surfaces. Do not
pull, twist, or wrap line cord around dryer, even
When using electrical appliances, especially when
during storage.
children are present, basic safety precautions should
6. Never block the air openings of the appliance or
always be followed, including the following:
place it on a soft surface, such as a bed or couch,
where the air openings may be blocked. Keep the
READ ALL INSTRUCTIONS
air openings free of lint, hair, and the like.
BEFORE USING
7. Never use while sleeping.
KEEP AWAY FROM WATER
8. Never drop or insert any object into any opening
or hose.
DANGER
9. Do not use outdoors or operate where aerosol
–
Any hair dryer is electrically
(spray) products are being used or where oxygen is
live even when the switch is off. To reduce the risk of
being administered.
death or injury by electric shock:
10. Do not use an extension cord to operate dryer.
1. ALwAYS UNPLUG IT IMMEDIATELY AFTER USING.
11. Do not direct hot air toward eyes or other heat-
2. Do not use while bathing or in a shower.
sensitive areas.
3. Do not place or store appliance where it can fall or be
12. Attachments may be hot during use. Allow them
pulled into a tub or sink.
to cool before handling.
4. Do not place in, or drop into, water or other liquids.
13. Do not place appliance on any surface while it
5. If an appliance falls into water, unplug it immediately.
is operating.
Do not reach into the water.
14. While using the appliance, keep your hair out of it.
Keep your hair away from the air inlets.
wARNING
– To reduce the risk of
15. Do not use with voltage converter.
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left unattended
SAVE THESE
when plugged in.
INSTRUCTIONS
2. This appliance should not be used by, on, or near
children or by individuals with certain disabilities.
3. Use this appliance only for its intended use as
described in this manual. Do not use attachments not
recommended by the manufacturer.
4. Never operate this appliance if it has a damaged
cord or plug, if it is not working properly,
or if it has been dropped into water. Return
OPERATING
CHECK ALCI SAFETY FEATURE EVERY
TIME YOU USE APPLIANCE
INSTRUCTIONS
This appliance is equipped with an Appliance
Leakage Circuit Interrupter (ALCI), a safety feature
This appliance is intended for household use only. Use
that renders it inoperable under some abnormal
on Alternating Current (60 hertz) only. Standard dryers
conditions, such as immersion in water. To make
sure the ALCI is functioning properly, perform the
are designed to operate at 110 to 125 volts A.C.
following test. The purpose of this test is to allow
This appliance has a polarized plug (one blade is wider
you to make sure the water sensing system (ALCI)
than the other). As a safety feature, this plug will fit in
is working.
a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit,
1. Plug in the appliance and press test button on
contact a qualified electrician. Do not attempt to defeat
plug (see appropriate diagram below).
this safety feature.
2. The appliance will stop working. There will be an
audible click and reset button will pop out.
IMPORTANT
3. To reset ALCI, unit should be unplugged. Then
push reset button in and reinsert plug into outlet.
1875 wATT OPERATING GUIDE
Use of this dryer on the same circuit or fuse
Reset
with other electrical products or appliances may
trip a 15 amp circuit breaker or blow a 15 amp
Test
fuse. NEVER replace the fuse with one rated
higher than the capacity of the circuit. Doing
so could result in an electrical fire.
4. If ALCI is not functioning properly, return
appliance to nearest service center.
5. It is important that if immersion occurs, this unit
be brought to a service center. Do not try to reset.
6. Be sure to repeat test every time you use the unit
to confirm ALCI is operational.
BODY & VOLUME
Should the appliance go off and the reset button
pop up during use, this could indicate a malfunction
To create extra volume, turn
in the unit. Remove plug from outlet and allow the
head upside down while drying.
appliance to cool. Reinsert plug into outlet.
Position the airflow toward the
roots for maximum lift. When
The appliance should then function normally. If not,
hair is dry, toss head back and
return to an authorized Conair Service Center for
brush hair into place.
evaluation and repair.
STRAIGHTENING
SUPER STYLING GUIDE
Work with hair in sections when
Your best looks begin with a good haircut that's well
creating a super-straight look.
maintained. Always treat hair right with superior quality
Using a large round brush
shampoos, conditioners, and finishing products.
(approximately 2" diameter),
hold hair taut in each section
DRYING BASICS
and bend ends slightly under
1. Shampoo and condition hair with products of your
as you dry.
choice. Rinse thoroughly. Towel dry hair to remove
MAKING wAVES
excess moisture. Using the dryer along with your
Tousled, natural-looking waves
styling brush, start at a lower setting and direct
are easily created by grasping
hot air through a section of hair at a time. Move
Reset
hair at the roots and scrunching
dryer steadily across each section so that the hot
between fingertips while drying.
air passes through hair. Direct air flow at hair, not
Test
scalp. Clouds of negatively charged ions will help
USING THE VOLUMIZING PIK ATTACHMENT
to reduce static electricity, control frizzy flyaways
1. Snap the volumizing pik attachment
and contribute to your hair's shine.
onto the barrel of dryer.
2. Keep dryer's air intake vents unobstructed and
2. Bring the fingers of the attachment
free from hair while drying.
to the scalp and gently rotate the
attachment in small circles to
3. To avoid over-drying, do not concentrate heat on
lift and volumize the hair from
any one section for an extended length of time.
the roots.
Keep dryer moving as you style.
3. The sloped wall around the pik
4. For quick touchups between shampoos, dampen
attachment helps to direct the air
hair with a mist of water before styling with
flow towards the roots of the hair,
the dryer.
to simultaneously dry the hair and create
lift as the attachment is being used.
5. When using your dryer to create curls and waves,
4. Repeat until all sections of hair
dry hair almost completely on a warmer temperature
have been volumized.
setting, then finish styling with cold shot feature
5. Press both attachment release
to quickly close hair shaft and lock in style.
buttons to detach volumizing pik
attachment from barrel of dryer.
GETTING TO KNOw YOUR DRYER
The Infiniti PRO by Conair
™
Volume Boost Styler
is very effective, even at lower temperatures,
Attachment
Ionic technology
and helps create healthier-looking, shiny, more
release buttons
manageable hair with maximum styling control.
1875 Watts
Powerful AC motor
POwERFUL AC MOTOR delivers fast airflow for
for longer life
styling ease and provides up to 3x longer life.
CERAMIC HEAT TECHNOLOGY is full spectrum
infrared heat works on molecules inside the hair
shaft, drying it inside and out. This fast and easy
Ceramic
drying process minimizes heat damage and
heat technology
makes hair less frizzy and more manageable.
Cold shot
button
THE IONIZING FUNCTION generates a cloud of
Removable
filter
3 heat settings
negative ions that can:
• neutralize the generally positive charge
2 speed settings
on flyaway, frizzy hair
• eliminate static electricity
• contribute to shine
select your setting
speed/temp.
delicate, thin, or
low/cool
easy-to-style hair
average-to-thick or
concentrator
volumizing pik
low/warm
treated hair
thick, coarse or
high/hot
hard-to-style hair
sets style in place for
cold shot
all hair types
hair type