AIRTUG HD Dumpster Tug Electric Instructions d'assemblage et d'utilisation - Page 6
Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage et d'utilisation pour {nom_de_la_catégorie} AIRTUG HD Dumpster Tug Electric. AIRTUG HD Dumpster Tug Electric 6 pages. Dumpster tugs 5,000 lbs
Imprimer la page
Tire Pressure: The tire pressure can range from 30 psi to the maximum tire pressure of 70 psi. It
should be reduced for added traction for lighter dumpsters. Lower pressures improve traction.
Batteries: Keep the batteries fully charged. The battery performance will diminish measurably as the
ambient air temperature drops.
Transaxle: This is a sealed unit and should not require maintenance or fluid.
Drive Wheel Bearings: Permanently lubricated.
Caster Zerk Fittings: Needs to be lubed periodically to ensure ease of caster wheel steering.
Drive Chains: Apply chain lube periodically depending on use and environment.
Battery Maintenance:
1.
New batteries require a full charge before use and need to be cycled several times before reaching full capacity.
2.
Battery connections should be kept tight at all times. Periodic inspection is recommended.
3.
Keep batteries clean from all dirt and corrosion.
4.
Batteries should not be discharged to the point of no longer being able to power the tug. Keeping the batteries fully
charged will greatly reduce the risk of a dead battery when you need it most.
5.
Batteries should be brought up to a full charge at the earliest opportunity using the built in 24V battery charger with
reverse polarity protection and float mode. The battery charger should be left on when the tug is parked to maintain
proper charging and maintenance of batteries at all times. Keeping the batteries fully charged will reduce the risk of
freezing in cold temperatures.
6.
Avoid charging the batteries when the ambient temperature exceeds 120
7.
Older batteries will take longer to fully charge.
8.
Periodic battery testing is an important preventative maintenance procedure. Voltage tests (open circuit, charged or
discharged) can identify a bad or weak battery. Load testing will identify a bad battery when other methods fail. A
weak battery will cause premature failure of a companion battery.
9.
Extreme temperatures can substantially affect battery performance and charging. Cold temperatures reduce battery
capacity and retard charging.
CAUTION:
* Read, study and understand all warnings and operating instructions prior to use
* ALWAYS WORK WITH YOUR "LOAD"/TRAILER BELOW THE TUG FOR SAFETY. THERE SHOULD NEVER BE A
PERSON BETWEEN THE OBJECT BEING MOVED AND A FIXED OBJECT.
* When working on the tug:
* Put the tug up on blocks to get the drive wheels off the ground before beginning any work.
* Do not allow anyone to stand directly in front of or behind the vehicle during testing.
* Make sure the Power switch is off.
* Use well-insulated tools.
* RUNAWAYS - Some conditions could cause the tug to run out of control. Disconnect the motor, or jack up the tug, and
get the drive wheels off the ground before attempting any work on the motor control circuitry.
* HIGH CURRENT ARCS - Electric vehicle batteries can supply very high power, and arcs can occur if they are short
circuit. Always turn off the battery circuit before working on the motor control circuit. Wear safety glasses, and use
properly insulated tools to prevent short circuit.
* Do not overload this tug beyond the rated capacity.
* This tug is designed for use only on hard level surfaces capable of sustaining the load.
* No alterations to the tug shall be made.
* Failure to heed these warnings may result in personal injury and/or property damage.
Dumpster Mover Heavy Duty (5000 lbs) Assembly & Operating Instructions
www.airtug.com
6
o
F.