Conant VRG7-2LFB Manuel d'instructions de montage - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Conant VRG7-2LFB. Conant VRG7-2LFB 10 pages. 2nd generation jeffersonian rain gauge
Imprimer la page
English
2
GEN JEFFERSONIAN RAIN GAUGE
ND
5. Screw the brass shaft
onto the lower threaded
connector. Tighten by
sliding the Allen wrench
through the hole at the
top of the inner pole
and twisting until the
poles are secure.
7. Carefully, cut the zip
ties that hold the glass
vial in place.
2. Place the base on the
deck and align the three
base holes with the three
newly drilled holes. Use a
Phillips screwdriver to
screw each of the three
screws into the deck. Be
careful not to tighten the
screws completely.
214 Eastern Avenue, Annapolis, MD 21403
6. Screw the rain gauge
onto the brass shaft. To
Brass Shaft
tighten, slide one of the
Allen wrenches through
the hole at the top of
the brass shaft and the
other Allen wrench
Foundation Rod
through the hole on the
shaft of the rain gauge.
Base
Then twist until both
sets are secure.
For Deck Mounting:
*FOR BEST RESULTS: Choose a spot on your deck that is as far
from the house as possible and is not near overhanging trees or
roof lines.
1. Place the base on the
deck where it is to be
installed and use a pencil
to mark the location of
Zip Ties
the three mounting holes
on the deck. Then use a
Glass Vial
drill with a 1/8" (4mm)
drill bit to drill three pilot
holes 1 1/2" (40mm) deep
into the mounting
surface.
3. Insert the foundation
rod into the top of the
base. Then screw the
level onto the top of the
rod to verify that it is
plumb. If the unit is not
level, use at pieces of
wood (shims) to slide
Base
under the base. When
you are done, unscrew
and remove the level.
www.conantcollections.com
Rain Gauge
Shims
410.263.9697
Brass Shaft
(1/8")
Foundation
Rod
Base
2