ADDER AdderLink Infinity ALIF2000 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} ADDER AdderLink Infinity ALIF2000. ADDER AdderLink Infinity ALIF2000 4 pages. Transmitter and receiver
Également pour ADDER AdderLink Infinity ALIF2000 : Manuel de démarrage rapide (4 pages)
Imprimer la page
ALIF1000 transmitter - rear panel
INDOOR
DVI-D
USE ONLY
OPTIONS
1
2
ON
1 2
A
B
C
D
5V
2.5A
ALIF1000 receiver - rear panel
INDOOR
USE ONLY
OPTIONS
DVI-D
1
2
ON
1 2
A
B
G
5V
2.5A
USER CONSOLE
A Power input
C USB port(s)
B Config switches
D Video input
ALIF2000 transmitter - rear panel
INDOOR
USE ONLY
OPTIONS
DVI-D-1
1
1
2
ON
1 2
A
B
C
D
5V
2.5A
ALIF2000 receiver - rear panel
DVI-D-2
2
A
B
C
G
5V
4A
LINE OUT
LINE IN
AUX
E
F
COMPUTER
LINE IN/
LINE OUT
AUX
MIC IN
C
E
F
E Audio line in/out
G Video output
F Serial config port
F
DVI-D-2
AUX
2
IN
OUT
D
E
COMPUTER
F
DVI-D-1
1
E
G
Configuration
• If ALIF TX and RX units are directly connected, no configuration
action is required, provided that they have their factory default
settings in place. If the standard settings have been changed in a
previous installation, you merely need to perform a factory reset
Note:
on each unit (see below).
ALIF1000
• Where ALIF units are connected via network links, you will need
units use
12.5W
to specify their network address details. This can be done by
power
connecting a computer system temporarily to each ALIF unit
adapters.
and using the Infinity browser-based configuration utility. This
configuration utility also allows numerous other settings to be
altered.
Note: For basic one-to-one installations, the factory default
addresses may be acceptable for immediate use within your
network without the need to use a configuration utility or change
their values: TX unit (169.254.1.33), RX unit (169.254.1.32).
Manual factory reset
Use to return a TX or RX unit to its default configuration.
1 Remove power from the ALIF unit.
2 Locate the small hole on the front panel: ALIF1000 - Next to the
only Ethernet socket; ALIF2000 - Next to the left-hand Ethernet
socket.
Note:
3 Push a narrow implement (e.g. a straightened-out paper clip) into
ALIF2000
units use
the hole and hold it in. Meanwhile, power on the unit.
20W
After around eight seconds, when the factory reset has
power
completed, five of the front panel indicators will flash for a period
adapters.
of three seconds to indicate a successful reset operation.
4 Remove the implement and then re-apply power to start the unit
in its default configuration.