Dan D'Agostino PROGRESSION M550 Manuel du propriétaire - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dan D'Agostino PROGRESSION M550. Dan D'Agostino PROGRESSION M550 9 pages.
Imprimer la page
Sound comes from only one channel
Follow the below steps in order. If one of these steps succeeds in restoring the sound,
stop there and ignore the other steps.
1. Check to make sure the face of the power meter is illuminated. If not, follow the
troubleshooting steps under "Amplifier will not power up" to restore power.
2. Check speaker cable connections for the malfunctioning channel. Reconnect any cables
that may have become disconnected. Inspect the cable to make sure it has not been
damaged. If it has been damaged, replace it.
3. Swap the left-channel interconnect cable from the preamp to the amplifier with the
right-channel interconnect cable. If the malfunctioning channel now works but the other
channel does not, replace the defective interconnect cable with one of the exact same
type. You may have to replace both right and left cables to make sure they match.
4. Swap the left-channel interconnect cable from the source device to the preamp with the
right-channel interconnect cable. If the malfunctioning channel now works but the other
channel does not, replace the defective interconnect cable with one of the exact same
type. You may have to replace both right and left cables to make sure they match.
5. Try using a different source device. If the alternate source device delivers sound in both
channels, it is likely the original source device is defective.
6. If possible, try using a different preamp. If the alternate preamp delivers sound in both
channels, it is likely the original preamp is defective.
7. If all of these steps fail to restore sound, consult your dealer for service.
Sound seems unclear or unfocused
Follow the below steps in order. If one of these steps fixes the problem, stop there and ignore
the other steps.
1. Play a CD (not a record) of a vocalist and sit in your usual listening position, which should
be equidistant from each speaker and typically 8 to 15 feet away from them. If the vocal
image appears centered between the speakers, they are connected correctly and your
system is probably operating properly.
2. If the vocal image is unfocused and the vocal seems to come from all over the room, your
speakers are probably wired out of phase. Make sure that the speaker cables are
connected correctly. The cable connector marked + or colored red should be connected to
the speaker binding post with the red ring. The cable connector marked – or colored black
should be connected to the speaker binding post with the black ring.
3. If the sound is still unclear or unfocused, consult your dealer. Your system may have a setup
problem outside the scope of this manual.
10
11