ADDER AdderLink X-DVIPRO-MS2 Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} ADDER AdderLink X-DVIPRO-MS2. ADDER AdderLink X-DVIPRO-MS2 16 pages. Adder pro dvi
Imprimer la page
Installation
CONNECTIONS
Installation of the X-DVIPRO and X-DVIPRO-MS2 modules is straightforward and
requires minimal configuration in most cases.
•
Connections at the local module
•
Connections at the remote module
Note: After all connections are made, power up the monitor and the REMOTE module first
(followed by the LOCAL module, if using the X-DVIPRO-MS2 variant) and then switch on the
computer.
Mounting the modules – desk or rack
The X-DVIPRO and X-DVIPRO-MS2 modules can be situated on a desk or alternatively,
for larger installations, mounted within an optional rack mount chassis.
Desk mount
Apply the supplied self-adhesive rubber feet to
the underside of the module.
Rack mount
1 Place the rack securing plate (available as a separate kit) onto the front of the module
and secure it with the two countersunk screws.
2 Orient the X-DVIPRO (or X-DVIPRO-MS2) module on its side so that its labeled face
is the correct way up.
3 Slide the module into the required rack position. The rectangular cut-out in the front
upper lip of the rack allows the two screws on the module's upper edge to slide
through.
4 The rack mount chassis has a series of holes in its floor that are spaced to
accommodate the two screws on the module's lower edge. Ensure that the screws
correctly locate into the two holes of the chosen slot. The rack securing plate
on the module should now be flush with the front of the rack mount
chassis.
5 Use the third (pan-head) screw, in the top hole of the rack
securing plate to fasten the module to the rack.
5