Elite Acoustics Engineering A1-4-CFB Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Elite Acoustics Engineering A1-4-CFB. Elite Acoustics Engineering A1-4-CFB 4 pages. Live-performance studio monitor with 3 channels, mixer, effects, and bluetooth
Imprimer la page
1.
Check that the Battery Switch [26] is set to the "Connect" position. (Battery Switch is
abuilt in circuit breaker to preserve battery life.)
2.
Make sure the SPEAKER VOLUME [3] control is turned all the way down.
3.
Connect microphones and/or instruments. You can use Channel 1 or Channel 2, or both.
Microphones are connected to the XLR MIC IN [18] and for 1/4" Line Levels signals use
[15].
4.
Turn on the POWER switch [25].
5.
If desired, connect a Bluetooth® [12] device; see Bluetooth® Function.
6.
Turn on your source signal(s) and adjust level for normal operation. Turn up GAIN [16]
until there is a solid green LED showing "signal" at the desired playing level. The red
"peak" LED, indicating too much signal, should only light for very brief periods, less than
one second, or not at all. Note: if you are using an iPhone or iPad via Bluetooth®, set the
volume on your device about halfway. Maximum volume will distort.
7.
Adjust the SPEAKER VOLUME [3] to a comfortable level
Power LED:
[1] Power: Blue indicates unit is on
[2] +48V LED: Orange indicates Phantom Power is on
Monitor Output Controls
[3] Speaker Volume: Control speakers' volume level
[4] Mono: Changes speaker output from Left Only to Mono
[6] Equalizer: Adjust High, Mid, and Low Frequency response
[5] Peak LED: RED indicates Signal Clip
[5] Signal LED: GREEN indicates Signal Present
[7] Aux Input/Level: Connect audio source with 1/8" jack from MP3/CD player, etc.
Effects Controls
[8] Effects Mix: Amount of effect being applied to output
[9] Rate/Decay: Controls the duration of the effect
[10] Effects Knob Selector: Select effect of choice
[11] EFX Bypass: Turn effects on or off (When LED is on, the effects are turned off)
Channel 1
[13] EFX Send Level: Adjust the level to "send" out
[14] +48V: Phantom Power control
[15] Line: 1/4" TS inputs
[16] Level: Apply gain for level control
[17] Mute: Mute channel
[18] Mic: XLR for Microphone Input
Channel 2/3
[19] Level: Apply gain for level control
[20] Left/Right Input: 1/4" mono TR input
[21] EFX Send Level: Adjust the level to "send" out
Monitor Output: Connect with extra speaker/monitor
[22] Output Source: Select source of XLR as Main mix or Direct Outputs for Chan 1 & 2
[23] Main Output: XLR Output
BLUETOOTH® FUNCTION
1.
Turn Bluetooth® function ON/OFF
Press the MODE button and hold for approximately 5 seconds
Both LEDs will flash at the same time
2.
Pair device to the speaker system
While both LED's are flashing, quickly tap the MODE button once
Both Flashing LED: indicate Bluetooth® is ready to be paired
Flashing Blue LED only: indicate Bluetooth® is connected
QUICK START