3onedata IES7110 Series Manuel d'installation rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} 3onedata IES7110 Series. 3onedata IES7110 Series 4 pages. Managed industrial ethernet switch
Imprimer la page
Model II
Model IV
1.
DIN-Rail mounting kit
2.
Grounding screw
3.
Relay alarm output terminal block
4.
Console port
5.
DC dual power supply input terminal block
6.
DIP switch
7.
AC single power supply input terminal block
8.
Relay alarm indicator ALM/Alarm
9.
Power supply input status indicator P1/P2/PWR
10.
Device running indicator RUN
11.
100M Ethernet port connection indicator
12.
Gigabit Ethernet port connection indicator
13.
1000Base-SFP Ethernet SFP slot
14.
10/100Base-TX Ethernet copper port
15.
100Base-FX Ethernet fiber port
16.
10/100/1000Base-T(X) Ethernet copper port
【Mounting Dimension】
Unit: mm
Model VI
Attention before mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
【DIN-Rail Mounting】
For convenient usage in industrial environments, the product
adopts 35mm DIN-Rail mounting, mounting steps as below:
Step 1
Check whether the DIN-Rail mounting kit that
comes with the device is installed firmly.
Step 2
Insert the bottom of DIN-Rail mounting kit (one side
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Step 3
Check and confirm the product is firmly installed on
DIN-Rail, and then mounting ends.
【Disassembling DIN-Rail】
Step 1
Power off the device.
Step 2
After lift the device upward slightly, first shift out the
top of DIN-Rail mounting kit, and then shift out the
bottom of DIN-Rail, disassembling ends.
Attention before powering on:
Power ON operation: first connect power line to the
connection terminal of device power supply, and then
power on.
Power OFF operation: first unpin the power plug, and
then remove the power line, please note the operation
order above.
【Power Supply Connection】
DC dual power supply
The products of model I, model III,
model V, model VII and model VIII
support DC dual power supply. And they
provide 4 pins power input terminal
blocks and two independent DC power
supply systems of PWR1 and PWR2.
The power supply supports nonpolarity and anti-reverse
connection. It can normally operate after reverse connection.
Power supply range: 12～48VDC
AC single power supply
The products of model II, model IV and
model VI support AC single power
supply and provide 4 pins 7.62mm pitch
power input terminal blocks. The definitions of terminal blocks
as follows: N/-, PG, L/+.
Power supply range: 100～240VAC/DC.
【Relay Connection】