ADDER Secure AS-4CR Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} ADDER Secure AS-4CR. ADDER Secure AS-4CR 5 pages. Smart card reader
Imprimer la page
CONFIGURATION
The configuration of the smart card reader is determined by the miniature switch block which is located on the
underside of the reader unit (in the top right corner when viewed with the rear panel cable pointing downwards).
The switch block has eight separate switches and the operation mode is determined by which switches are set to
the ON position:
#
Mode
Description
1
Manually associate
In this mode, press the number button on the smart card reader
and retain individual
for the computer you wish to associate your card with. The card
channels
will remain associated with the computer even when another
computer channel is chosen.
2
Auto associate
In this mode, the smart card reader will automatically associate
channels by activity
itself with the computer that requires smart card access, based
detection
on its activity detection algorithm.
3
Auto associate
In this mode, the smart card reader will automatically associate
channels by power-
itself with the computer that requires smart card access, based
detection
on its power detection algorithm.
4
Device Manager mode
DM mode determines whether the smart card reader should
remain mapped to a computer's device manager if the card is
removed. This option is only applicable when used in conjunction
with other modes, eg this mode plus Auto association by activity
detection (ie modes 4 + 2).
When DM mode is not used, the reader will be disconnected
from a computer's device manager whenever the smart card
is removed. This may cause compatibility issues with some
applications.
5
Auto associate by
In this mode, the smart card reader will automatically associate
activity and power
itself with the computer that requires smart card access, based
detection
on either its activity or power detection algorithms.
6
Auto associate by
In this mode, the smart card reader will automatically associate
activity and power
itself to the computer which requires smart card access based on
detection plus Device
either activity or power detection (depending on the smart card
Manager mode
type). Upon smart card removal the DM mode will cause the
(default setting)
reader to remain mapped to the computer's device manager, just
as a standard smart card reader would.
7
Manually associate
In this mode, press the number button on the smart card reader
with one channel
for the computer you wish to associate your card with. When
at a time
another button is pressed, your card will be de-associated from
the initial computer and connected with the new computer.
8
Manually associate and
In this mode, press button 1 when you are ready for your card
retain all channels
to be used. The reader will then associate your card with all
connected computers.
DRAFT
To configure the smart card reader
1 With the smart card reader powered on or off,
locate the switch block on the underside of the
unit.
Switch settings
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
2 Gently remove the switch block cover.
3 Change the on/off status of the switches as
shown left to match the required operation
mode.
1 2 3 4 5 6 7 8
4 Replace the switch block cover.
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
8-way switch block
2