Anywave Marble PA-U-1200-D-FB Manuel de démarrage rapide - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Anywave Marble PA-U-1200-D-FB. Anywave Marble PA-U-1200-D-FB 18 pages.
Imprimer la page
Your TX should now be up and running properly into your load or on-air antenna.
Continue to monitor system parameters as you allow the transmitter to operate and
stabilize at full output power for another 30 minutes.
15) Navigate to the CAL setting under the AD3 Advanced submenu and select CAL
then press OK to calibrate the FWD PWR meter on the Exciter front panel to 100%.
16) To turn the TX On/Off, please use the RF On/OFF control in the RF submenu of
the exciter LCD or the exciter web interface. You may also use the TX ON/OFF
button on the PA's Home page, as shown below.
17) For Remote TX Monitoring and Control, you may network to the PA LAN RJ-45
rear panel connection at 192.168.1.200 – you can change the PA IP address by
navigating to the Config submenu on the PA's touchscreen, then press the Network
button, and change the value of IP, or you can change it via the PA's Web Interface.
You may also network to the Exciter REMOTE RJ-45 rear panel connection at
Mable 4Device Quick Start Guide, 5/19/2022
Marble 4Device Quick Start Guide
Page 15 of 18