DUDOFF GD-Z01 Manuel d'installation et d'utilisation - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} DUDOFF GD-Z01. DUDOFF GD-Z01 17 pages. Built-in gas hob domino
Imprimer la page
8/A) INSTALLING THE HOT PLATE
WITH THE BATTERY
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children's reach since they could become
potential sources of danger.
The measurements of the opening made in the top
of the modular cabinet and into which the hot plate
will be installed are indicated in either fig. 8. Always
comply with the measurements given for the hole
into which the appliance will be recessed (see fig. 8
and 9).
The appliance belongs to class 3 and is therefore
subject to all the provisions established by the
provisions governing such appliances.
8/B) FIXING THE HOT PLATE
The hot plate has a special seal which prevents liquid
from infiltrating into the cabinet. Strictly comply with
the following instructions in order to correctly apply
this seal:
- take off all the movable parts of the hob.
- Detach the seals from their backing, checking that
the transparent protection still adheres to the seal
itself.
- Overturn the hot plate and correctly position seal
"E" (fig. 10) under the edge of the hot plate itself, so
that the outer side of the seal perfectly matches the
outer perimetral edge of the hot plate. The ends of
the strips must fit together without overlapping.
Evenly and securely fix the seal to the cooktop,
pressing into place with the fingers and remove
the strip of protective paper from the seal and set
the plate into the hole made in the cabinet.
INSTALLATION
FIG. B
- Unscrew the ignition cap "T" (see fig. B) and fit a
1.5 V battery (not included in the appliance) with
the positive "+" polarity turn inside.
Rescrew the cap.
- Position the hob in the hole in the unit and fasten it in
place using the appropriate screws "F" and the
fastening hooks "G" (fig. 11).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the working,
is necessary to put a wooden insert, fixed by
screws, at a minimum distance of 70 mm from the
top (see fig. 8).Remark: below is the suggested
clearances. Actual installation will be veried subject
to different kitchen situations.
REPLACING THE BATTERY
To change the battery (see fig. B) comply with
following instructions:
- unscrew cap "T" and remove exausty battery.
- Insert a 1.5 V new battery. The positive polarity "+"
is turn over inside.
- Rescrew the cap "T".
- Re-assembly all the movable parts.
WARNING:
the batteries contain a dangerous material for our
ambient. Always put them in a separate and safe
container.
If you eliminate your appliance, remember to take off
the battery.
IMPORTANT:
rechargeable or not rechargeable.
The rechargeable battery shall be removed
from appliance before being recharged.
Do not attempt to recharge the not
rechargeable batteries.
The power supply poles shall not be short
circuited.
11
The
battery
can
be