Duerkopp Adler 527 Manuel d'instructions - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Duerkopp Adler 527. Duerkopp Adler 527 12 pages. For setting individual mechanisms
Imprimer la page
11. Adjustment of the hook timing (Fig. 9, 10)
Caution! Danger of injury!
Switch off the main switch! Before starting the setting operation, wait until the motor stops!
Set a zero zigzag sitch on the machine. Turn the hand wheel towards ourselves, until the needle bar descends in its lowest point
and then ascends by 2.8 + 0.2 mm upwards. In this position, the hook point must be on the needle axis. The max. space between
the needle and the hook is to be 0.05 mm. If it is not so, dismount the throat plate proceed to the correct setting of the hook timing
using the locating fixture. When the needle bar is in its lowest position, screw on the locating fixture (Fig. 9) onto the needle bar
together with gauges giving the hook timing size, namely 2.8 + 0.2 mm.
Secure the correct hook position in tightening the screws and proceed to the mounting of the throat plate.
12. Setting of the middle part of the hook holder (Fig. 11, 12)
Caution! Danger of injury!
Switch off the main switch! Before starting the setting operation, wait until the motor stops!
Set the middle part hook holder (7) in such a way, so that the space between the holder nose and the bottom of the groove of the
middle hook part is about 0.7 mm. Proceed to this setting after having loosened the holding screw (10) using a locating jig (Fig.
11) - see equipments part A, par. 4.2, 4.4.
Fig. 9
10
7
4
Fig. 10
Fig. 11