3onedata GW1108 Series Manuel d'installation rapide - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} 3onedata GW1108 Series. 3onedata GW1108 Series 5 pages. Modbus gateway
Imprimer la page
at the same time. The interface type is RJ45 and its pin
:
definitions are as follows
PIN
1
2
3
4
5.
RS-232 DSR RTS GND TXD RXD DCD CTS DTR
RS-485 —
—
GND —
—
RS-422 —
R-
GND R+
—
RS-485/ 422 interface
The model III of this series provides 5-Pin
5.08mm pitch terminal blocks. The serial
port is isolated and its pin definitions are
:
as follows
PIN
1
2
3
RS-485
D+
D-
GND
RS-422
T+
T-
GND
【Checking LED Indicator】
The device provides LED indicators to monitor the device
working status with a comprehensive simplified
troubleshooting; the function of each LED is described in the
table as below:
LED
Indicate
Description
PWR is connected and running
ON
normally
PWR
PWR is disconnected and running
OFF
abnormally
System runs normally
Blinking
The system is not running or running
RUN
OFF
abnormally
System is running abnormally
ON
Copper port has established an
ON
active network connection.
Copper port is in a network activity
LINK
Blinking
state.
Copper port has not established an
OFF
active network connection.
LED
Indicate
OFF
6
7
8
TX(1-8)
Blinking
D-
—
D+
T-
—
T+
OFF
RX(1-8)
Blinking
【Logging in to WEB Interface】
This device supports WEB management and configuration.
Computer can access the device via Ethernet interface. The
4
5.
way of logging in to device's configuration interface via IE
—
—
browser is shown as below:
Step 1
Configure the IP addresses of computer and the
R+
R-
device to the same network segment, and the
network between them can be mutually accessed
Step 2
Enter device's IP address in the address bar of the
computer browser.
Step 3
Enter device's user name and password in the
login window as shown below.
Step 4
Click "OK" button to login to the WEB interface of
Description
No data or abnormal data is being
transmitted through serial port.
Serial port is transmitting data.
Serial port is not receiving data or
receiving data abnormally
Serial port is receiving data.
the device.
Notes:
The default IP address of the device Internet access is
"192.168.1.254".
The default user name and password of the device are
"admin".
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【Specification】
Panel
100M Copper Port
10/100Base-T(X)
RJ45 port
Serial Port
3IN1 RJ45 interface, RS-485/422
terminal blocks with isolation or
RS-232 RJ45 interface
Indicator
Power
indicator, Copper port connection
indicator, Serial port transmission
and receiving data indicator
Power supply
Input power supply
9~48VDC or 12~48VDC
Access terminal block
2-Pin or 3-pin 5.08mm pitch
terminal blocks
Power consumption
No-load
3.16W@12VDC
Full-load
3.90W@12VDC
Working environment
self-adapting
indicator,
Running