Duevi RX2AP Manuel d'installation et d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Duevi RX2AP. Duevi RX2AP 4 pages. Two outputs radio receiver

Imprimer la page
6.
"LIGHT TIMER" MODE
This mode (DIP3 = ON) set the receiver to maintain active the Relay outputs for 3 minutes (useful as light timer) when it is received a radio code from a remote control,
a sensor or the "alarm" code of a TSR. The remote controls and TSR transmitters must be stored only in Relay A zones (Radio Zones A-1 ÷ A-5).
During this time the receiver will not react to any command.
DIP2 = ON
By pressing once the BIG button of a remote control, the Relay A is activated – Pressing it again, the Relay A releases
The Relay B is activated for 3 minutes when it is received an alarm code from a sensor stored in Radio Zones B (the sensors stored in Radio Zones A are
ignored)
DIP2 = OFF
The Relay A is activated for 3 minutes when it is received a radio code (sensor, remote control or TSR "start alarm") from Radio Zones A
The Relay B is activated for 3 minutes when it is received an alarm code from a sensor stored in Radio Zones B
7.
USE OF THE TSR TRANSMITTER
The receiver can be paired with TSR (transmitter for sirens) to visualize from remote the alarm system status.
The TSR transmitters must be stored only in Relay A zones (Radio Zones A-1 ÷ A-5). The remote controls must be stored only in Relay A zones (Radio Zones A-1 ÷ A-5).
The receiver works differently depending on DIP2 setting:
DIP2 = ON
The Relay A is activated when it is received the "ARM" code of a TSR, and releases when it is received the "DISARM" code
By pressing once the BIG button of a remote control, the Relay A is activated – Pressing it again, the Relay A releases
By pressing once the SMALL button of a remote control, the Relay B is activated – Pressing it again, the Relay B releases
The Relay B is activated for 2 seconds when it is received the "START ALARM" code of a TSR or an alarm code of a sensor stored in Radio Zones B
DIP2 = OFF
The Relay A is activated for 2 seconds when it is received an "ALARM" code of a TSR or any code of a remote control or an alarm code of a sensor stored in
Radio Zones A
The Relay B is activated for 2 seconds when it is received a "STOP ALARM" or "DISARM" codes of a TSR or an alarm code of a sensor stored in Radio Zones B
BI-STABLE
MONO-STABLE
BI-STABLE
MONO-STABLE
This device meets the R&TTE requirements (European Union)
4
DIP1 = OFF | DIP3 = ON | DIP4 = OFF
DIP1 = OFF | DIP3 = OFF | DIP4 = OFF