Abundant Flow Water Zoi DFK-Zeta Manuel d'entretien - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Abundant Flow Water Zoi DFK-Zeta. Abundant Flow Water Zoi DFK-Zeta 16 pages. Reverse osmosis water filtration system zoi series; mb-1812-50f

Imprimer la page

2. Locate cold-water angle shut off valve underneath the sink,

usually on the right side, and turn it off. Open cold water faucet

to release the pressure. On single handle faucets, turn the hot

water off to prevent cross over. If water is not stopped

completely, turn off main water supply

3. The angle shut of adaptor is installed directly on the on the cold

water angle shut off valve.

Flex line Instructions

Loosen nut and separate cold water line

from angle shut off valve. Ensure the O-

ring is in place on the angle valve

adapter and screw in place on the angle

shut off valve. If washer in flex line is

worn

damaged,

continuing to prevent any leaks. Gently

bend flex line so that it will fit over the

angle valve adapter and tighten flex line

onto angle valve adapter.

Copper Instructions

Loosen nut and separate cold water line

from angle shut off valve. You will need

to cut a piece of the copper tube about

3/4" to 1" (measure to determine the

exact cut needed) so the angle valve

adapter can fit between the angle shut

off valve and the copper line. Ensure the O-ring is in place on

the angle valve adapter and screw in place on the angle shut off

valve. If washer in copper line is worn or damaged, replace

before continuing to prevent any leaks. Push the copper pipe

into the angle valve adapter and tighten down the compression

nut.When connecting the system the feed water line connects

to the angle valve adapter.

Drain Saddle Installation:

The drain saddle consists of two (2) halves, (one half has a fitting

on it), two (2) bolts with nuts, & a rubber seal. It is used to direct

the waste water from your system down the drain. Depending on

where the saddle is located, you may hear water running down

the drain when the system is making water, this is normal. If the

sound is annoying, the drain line may be pushed farther in to help

replace

before

Revised 10/2014

NOTE: The system will automatically turn on whenever water is

drawn out of the tank. When the system is on & making water

there will be water going down the drain, this is normal. Once the

tank is full pressure build up in the system will activate the auto

shut off valve, cutting the water supply to the membrane and

stopping the flow of water down the drain. How long it takes for

the wastewater to shut off depends on many variables, including

the amount of water taken out and water pressure.

System Maintenance

Filters:

Filters need changed regularly to ensure protection of the

membrane and high purity water production.

Refer to the chart below for the specific filter set needed for your

system. Filter kits, as well as individual and specialty filters may be

ordered securely online at www.afwfilters.com or by calling 785-

735-9769. With average usage and normal water conditions filters

should be changed every 6 months. The more water you use or

the dirtier your water the more often you will want to change

filters. If the first filter (sediment filter) gets dirty quickly it may

need changed more often than the rest, part number for the

individual sediment filter is RF-SED10-5. All filters (excluding the

membrane) should be changed at least every 12 months.

To change filters:

Note: The tank will need to be emptied when changing filters. If

you would like to save the water in the tank for use, follow the

instructions below, opening the faucet and collecting the water

from the tank after turning the feed water off.