DUKER 305 Manuel d'utilisation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} DUKER 305. DUKER 305 14 pages. Underground fire hydrants
1. Intended Use
After the installation into a pipe system, shut-off valves are only intended for stopping or
allowing media to
pass within the range of the permitted operating conditions (temperature and pressure limit
"PN" labeling on
the valve, unless stated otherwise).
These valves are preferably intended for liquid media, such as drinking water, process water, raw and
waste water. Any deviating operating conditions or areas of application are subject to manufacturer
approval.
We will not assume any responsibility for consequential damage caused by
unauthorized modification of the valve and the accessories supplied
improper operating or operating conditions
acts of God
Continuous operation of the valve in an intermediate position will lead to increased wear of the valve
or the subsequent pipe system up to total destruction and should therefore be avoided.
Cavitation can be identified among other things by:
Increased noise level
Crackling noise
Severe vibrations
Cavitation can be avoided by operating the valve only in fully OPENED or fully CLOSED position.
2. Safety Precautions
2.1. General safety instructions
The same safety regulations apply for valves as for the pipe system in which they are installed. The
following instructions only include additional safety instructions to be observed for valves.
2.2. User safety instructions
The operator of the valve must ensure that the valve is only used in accordance with the intended use.
This is not the responsibility of the manufacturer. The valve may only be operated by properly qualified
and trained staff. The operating manual and the corresponding safety instructions must be read
and understood.
It is prohibited to use any valves with a nominal pressure ("PN") and maximum admissible operating
temperature insufficient for the operating conditions.
The approved range is indicated on the valve.
Warning: Temperatures below 10°C and above 40°C during work on the pipeline parts involve the risk of
injury. Protective measures must be taken accordingly.
Operating media must correspond to the specification of the valve. The manufacturer does not
01/042017
Düker GmbH, www.dueker.de
3