Dumor HLF1710 Manuel d'assemblage - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} Dumor HLF1710. Dumor HLF1710 3 pages. 24" dumor rabbit cage starter kit
Imprimer la page
Step 3. Dropping Pan, Metal Feeder and Water Bottle Set Up
Dropping Pan:
Slide the dropping pan into the horizontal dropping pan
supports until centered underneath the cage.
Metal Feeder:
1.To install the rabbit feeder a small opening must be cut
on one side of the cage.The bottom chute of the
feeder requires a 6.25"(L) X 2"(W) opening. Determine
a desired placement of the feeder. It should be low
enough so rabbit can reach it comfortably.
2. With small wire cutters (not supplied) cut one
adjacent horizontal wire and one adjacent vertical
wire close to the outer wires to the 6.25" (L) X 2"(W)
opening. Remove all sharp edges after cutting to
prevent injury to the rabbit.Slide the bottom spout
of feeder through the opening and push the wire
frame through the mesh. The hook of the wire
should go through two horizontal wires of the mesh.
Step 4. You can stack 2 cages on top of each other
using the four stacking lugs. Insert 1 stacking
lug in each frame leg-gently place additional
cage on top and secure.
Assembly time: 15 minutes
Required for Assembly: 1 person
Tools required: 2 small adjustable wrenches or 2 - 10 mm wrenches and 1 small wire cutter
Water Bottle:
1. Determine the proper height for the drinking nozzle for your pet.
2. Hang the metal water bottle support on the appropriate
horizontal wire to maintain the desired height for drinking.
3. Fill the bottle with water to desired amount, secure lid and
attach nozzle.
4. Place water bottle nozzle down into the water bottle
support. The bottle must be set completely vertical to allow
proper nozzle ball seating in order to prevent leaks.
Page 3
Distributed by:
TRACTOR SUPPLY COMPANY
5401 VIRGINIA WAY
BRENTWOOD, TN 37027
For customer support,
call: 1-888-376-9601
www.TractorSupply.com
MADE IN VIETNAM