Danfoss iC7 Series Manuel d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Danfoss iC7 Series. Danfoss iC7 Series 14 pages. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Également pour Danfoss iC7 Series : Manuel d'installation (8 pages), Manuel d'installation (8 pages), Manuel d'installation (6 pages), Manuel d'installation (16 pages), Manuel d'installation (8 pages), Manuel d'installation (8 pages), Manuel d'installation (10 pages), Manuel d'installation (16 pages), Manuel d'installation (16 pages), Manuel d'installation (6 pages), Manuel d'installation (6 pages), Manuel d'installation (16 pages), Manuel d'installation (18 pages)

In-bottom/Out-top Cooling Kit for FA11-FA12

Installation Guide

With the rubber seal in place, carefully slide the inner sleeve of each duct into the outer sleeve.

Illustration 7: Assembly of Telescopic Ducts

Inner sleeve of duct

Ribbed EPDM rubber seal

2.6 Installing the Top Duct Over the Top Vent

To attach the top duct over the top vent of the frequency converter, use the following steps. See

Procedure

Remove 2 M5x14 screws (T25) at the back of the top vent, and retain the screws.

Remove 3 M5x12 screws (T25) at the front of the top vent, and retain the screws.

Position the top duct over the vent in the top of the frequency converter.

Line up the holes in the lower flange with the screw holes in the frequency converter.

Secure the lower flange to the frequency converter with 5 screws (T25) previously removed.

Torque fasteners to 2.3 Nm (20 in-lb).

Outer sleeve of duct

Illustration

AN361429548582en-000201 / 136R0255

Installation