Aolait AL120Twins Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aolait AL120Twins. Aolait AL120Twins 20 pages. Dual head 2r moving head light

Imprimer la page

Hanging

1. OMEGA bracket lamp installed on the hook and tighten the screws

2. The OMEGA bracket to lamp base, clockwise tightening fast lock

3. Lamps on each side of a person, lift the fixture, the lamp poles and locking snap hook

4. The insurance rope through the base hole, and tied to a pole

Installation Notes:

1． Confirm hook hanging lamps and accessories undamaged and can withstand 10 times the

total weight of the lamps and cables and accessories, etc.

2． Note that the lamp lighting the front direction of the bottom body portion of the base

label

3． Installation, maintenance, and mobile lighting should have a stable platform, which

should have a security fence just below.

4． The insurance insurance rope through the rope hole lamp base, and tied to the lamp housing,

shall not tied to the handle

5． Check the lamp housing do not have the range of combustible material within 0.2 meters,

lamps light beam directed not to be blocked within 10 meters, and the neighborhood do

not have flammable substances

6． Check the lamps are not likely to collide with each other at the time of exercise

7． Check other lamps are not directly irradiated on this fixture, a strong light can damage

the protective shell lamps

8． Always make sure when you put the installation being installed in a horizontal plane,

so as not to slip occurs when the shell running lamps

Power Supply

To prevent electric shock, lamp must be grounded, the main power circuit

breaker must have insurance and switches and ground fault protection

Please fixtures directly connected to an AC power source, not connected

to the silicon box to prevent damage to the lamp

Power Input

Lamps internal switching power supply with PFC power supply voltage AC100V-240V 50 / 60Hz

Power Connection:

Plug the power cord has been installed a lighting power connector with mating plug the other

end should install an appropriate power plug, three-pin plug with grounding. Must follow

the manufacturer's instructions to install. The following table shows some plug pin

connector recommendations. If you are unsure or have questions, please consult a qualified

electrician. To power, the power switch should pull to the position "I"。

WARNING：